How to fix Bsod upon boot Acer Aspire A515-54Xm

124»

Answers

  • Triple3
    Triple3 Member Posts: 45

    Tinkerer

    JackE said:
    Please don't try to set Legacy mode or you risk losing everything on or irreparably corrupting the HDD (or SSD). So I must now ask if you ever tried boot the USB Win10 installation pendrive when the BIOS was set to Legacy mode? Jack E/NJ
    Yeah.... although it doesn’t look like any damage was done to it more than what was done before. Everything turned out the exact same even after I had legacy on. I turned it off and did your steps and I still got the same results from before I had legacy turned on so I don’t think anything happend.

    i booted from the USB in legacy mode once and it loaded in normally except it did the spinning windows logo thing for a few seconds then loaded into the pen drive in like 480p resolution 
  • JackE
    JackE ACE Posts: 44,897 Trailblazer
    With secure boot disabled and only the HDD connected, try to boot to the USB drive again. Press Shift+F10 again to enter the elevated X prompt. Fire up diskpart again. Then see if the following two diskpart commands work this time around. Jack E/NJ

    Select Disk 0
    Attributes disk clear readonly

    Jack E/NJ

  • Triple3
    Triple3 Member Posts: 45

    Tinkerer

    JackE said:
    With secure boot disabled and only the HDD connected, try to boot to the USB drive again. Press Shift+F10 again to enter the elevated X prompt. Fire up diskpart again. Then see if the following two diskpart commands work this time around. Jack E/NJ

    Select Disk 0
    Attributes disk clear readonly

    I tried that yesterday knowing you’d tell me to do it. I did that and also reformatted both volumes and did the disk clear and it said the same thing as before. Failed to clear
  • JackE
    JackE ACE Posts: 44,897 Trailblazer
    Go to this link to download the Win10 version 1511 iso. Then use Rufus to create a bootable USB stick from the iso. Boot to the 1511 installation menu. Press shift+F10 again. Then see if these two v1511 diskpart commands do the job.

    Select Disk 0
    Attributes disk clear readonly

    Jack E/NJ

    Jack E/NJ

  • Triple3
    Triple3 Member Posts: 45

    Tinkerer

    JackE said:
    With secure boot disabled and only the HDD connected, try to boot to the USB drive again. Press Shift+F10 again to enter the elevated X prompt. Fire up diskpart again. Then see if the following two diskpart commands work this time around. Jack E/NJ

    Select Disk 0
    Attributes disk clear readonly

    So I only have one usb so do I delet the windows thing from it and replace it with this rufus stuff...?