How can I calibrate the antennas of my Acer Predator Connect W6?Connect a LAN cable to any of the LAN ports of the Predator Connect W6 (or connect via Wi-Fi).Open an internet browser on your computer and type one of the following into the search bar of your browser:http://acerconnect.com192.168.76.1Enter your admin password.Click on Log in. In the main menu, click on WiFi.Click on Antenna calibration. Move your device to your preferred location. Switch the Calibration mode toggle on to start the calibration.The LEDs of each antenna on the Predator Connect W6 will light up: Blue: Signal is good.Green: Signal is normal.Red: Signal is weak.If the LEDs are red, adjust the antennas to optimize the signal (all LEDs are blue). After optimizing the antennas, switch the Calibration mode toggle off to end the calibration process.