CPU Cooler Fan Runs on High Speed and PC is not Booting

xxasdzz
xxasdzz Member Posts: 2 New User

Dears,

 

I have Acer Veriton M265 desktop pc. Till yesterday, PC was working fine and i shut it down properly. Today i came and i turn-on the PC but CPU fan start running on very high speed as well as PC is not booting. I can see only the BIOS screen then nothing (only blank screen).

 

Kindly help me.

Answers

  • alicepattinson
    alicepattinson Member Posts: 160 Troubleshooter

    Are you having some virus or malware problems lately?

  • xxasdzz
    xxasdzz Member Posts: 2 New User

    not at all. it was working perfectly. Late eveining, i shut down the system properly but next morning, it wont come up. :-(

  • goalie
    goalie Member Posts: 7 New User

    If your desktop is 5 years old or older, it might be the CMOS (system) battery.  We had a similar stuation and changing the battery (approximately $5) resolved the issue.

  • RBent
    RBent Member Posts: 1 New User

    I have the same exact problem. I also changed the CMOS battery but still no luck. It would randomly show BIOS but now it's just not recognizing monitor input. Any suggestions would be great. Memory is fine because I tested it in same exact machine. I also, I had changed the PSU unit with a 350W one.

  • laurent_14
    laurent_14 ACE Posts: 10,315 Trailblazer

    Hello RBent,

     

    You can do another test if you have a graphic card:

     

    OFF VOLTAGE

     

    - Remove the graphic card

    - Connect directly the monitor on the vga port of the motherboard

      (Don't install any driver - It's just a test)

     

    If you have no video signal + the others problems, your motherboard is dead.

     

    Note: Why had you changed the PSU?

    France
  • Marc810
    Marc810 Member Posts: 4 New User
    I had the same problem, cleaned all the dust that was clogging up the fan, took the ram out and put it back in. Solved the problem. I think if the date and time are ok then the CMOS battery is ok. I also took that out then put it back in. Give it a try, worked on mine.
This discussion has been closed.