How to turn monitor off on an all in one Acer C24! (Model C24-1300)

doctorking1
doctorking1 Member Posts: 5

Tinkerer

edited March 31 in All-In-One PCs

I have a recently purchase Acer C24. I cannot find out how to turn the monitor off without turning the computer off. Any ideas please? I spoke to Acer customer services today and they didn't think there was an option. I can set the brightness level to dim and the screen to go off, but not for the actual monitor to turn off!

[Edited the thread to add model number to the title]

Answers

  • Jack22
    Jack22 ACE Posts: 4,180 Pathfinder

    @doctorking1

    The power button is at the bottom, check the below picture

    Click on 'Yes' if the comment answers your question!
  • billsey
    billsey ACE Posts: 34,672 Trailblazer

    There are two ways you can deal with it… Setup a screen saver with a blank screen or set the power options to turn the display off after a certain time of no use. The latter is likely your best bet.

    Click on "Like" if you find my answer useful or click on "Yes" if it answers your question.
  • doctorking1
    doctorking1 Member Posts: 5

    Tinkerer

    Thanks Jack - that is a different monitor sadly.

  • doctorking1
    doctorking1 Member Posts: 5

    Tinkerer

    @Jack22 thanks but that is a different monitor sadly.

    @billsey thanks

  • billsey
    billsey ACE Posts: 34,672 Trailblazer

    There have been a lot of different C24 models over the years. When asking a question it's always best to give us the full model number… Your full model number is usually on the same sticker as your serial number, it should look something like C24-xxx-xxxx.

    Click on "Like" if you find my answer useful or click on "Yes" if it answers your question.
  • doctorking1
    doctorking1 Member Posts: 5

    Tinkerer

    @billsey thanks - C24-1300 is the actual model

  • billsey
    billsey ACE Posts: 34,672 Trailblazer

    So yes, the C24-1300 models don't have a way to just turn off the monitor physically, so your best bet it to use the Windows power options to turn it off after some time of inactivity. You will still get a small amount of power draw, but that allows it to wake back up when you move the mouse or press a key.

    Click on "Like" if you find my answer useful or click on "Yes" if it answers your question.
  • doctorking1
    doctorking1 Member Posts: 5

    Tinkerer

    thanks very much