Need help to get out of black screen on Aspire 5 A515-56G-71JH

Rene65
Rene65 Member Posts: 7

Tinkerer

edited July 2021 in Aspire Laptops
Have a few months old Aspire 5 laptop. Worked fine until I swiped keyboard and somehow must have activated F6 blackcreen and can't get screen back. When booting up the Acer logo appears but then screen foes black. Attaching an aux screen works fine, the laptop just doesn't see the screen anymore. When booting up I can call up BIOS and see it on laptop screen but as soon as I get out again the screen is black and only aux screen is recognised. Any suggestions ?

Thread was edited to add model name to the title



Best Answer

Answers

  • JackE
    JackE ACE Posts: 44,891 Trailblazer
    edited July 2021
    Try pressing FN+F6 to turn the screen back on. Or FN+F5.

    Jack E/NJ

  • Rene65
    Rene65 Member Posts: 7

    Tinkerer

    tried that but no effect
  • JackE
    JackE ACE Posts: 44,891 Trailblazer
    edited July 2021
    Turn machine off. Remove charger. Insert paper clip into reset pinhole on bottom for about 30 seconds. Plug charger back in. Wait for battery charge LED to turn from steady orange to steady blue. Turn machine back on and immediately start tapping F2 key to re-enter BIOS menu. Press F9 to set default. Press F10 to save settings and exit.

    Jack E/NJ

  • Rene65
    Rene65 Member Posts: 7

    Tinkerer

    Battery is inside the casing, ie not easily removable. Will try to drain it to the max and then inset paperclip in pinhole and subsequent steps. Tried as is i.e. without drained battery but that didn't work.

  • JackE
    JackE ACE Posts: 44,891 Trailblazer
    You don't have to remove the battery. The paperclip reset disconnects the battery from the mainboard. Press and hold the paperclip in the pinhole  for about 30 seconds. Then plug charger back in. Wait for battery charge LED light to turn from steady orange to steady blue. Turn machine back on and immediately start tapping F2 key to re-enter BIOS menu. Press F9 to set default. Press F10 to save settings and exit. Then see if screen will stay on after exiting the BIOS menu.

    Jack E/NJ

  • Easwar
    Easwar Member Posts: 6,727 Guru
    Hi Rene65,

    # Try to get the BIOS page.
    1. Turn OFF the unit.
    ​2. Press and hold the F2 key and turn on the unit. 
    3. You will be in setup utility page. 
    4. Once you got the screen release the F2 key.
    5. Tap on F9 key and hit enter key without changing the option.
    6. Tap on F10 key and hit enter key without changing the option.
    7. Your unit will restart by itself. 

    Check this T/S and post the result. ​
  • JackE
    JackE ACE Posts: 44,891 Trailblazer
    You don't have to remove the battery. The paperclip reset disconnects the battery from the mainboard. Press and hold the paperclip in the pinhole  for about 30 seconds. Then plug charger back in. Wait for battery charge LED light to turn from steady orange to steady blue. Turn machine back on and immediately start tapping F2 key to re-enter BIOS menu. Press F9 to set default. Press F10 to save settings and exit. Then see if screen will stay on after exiting the BIOS menu.

    Jack E/NJ

  • Rene65
    Rene65 Member Posts: 7

    Tinkerer

    @ JackE and Easwar: tried both but didn't solve the problem ...
  • JackE
    JackE ACE Posts: 44,891 Trailblazer
    What is your full A5 model number? For example, A515-43?

    Jack E/NJ

  • Easwar
    Easwar Member Posts: 6,727 Guru
    Hi Rene65,

    Are you getting any light indication when charger is connected. Is the unit battery charged enough to run the system.
  • Rene65
    Rene65 Member Posts: 7

    Tinkerer

    Hi Jack E/NJ
    model is A515-56G-71JH
  • Rene65
    Rene65 Member Posts: 7

    Tinkerer

    Hi Easwar, yeah battery is fully loaded, can work for hours with an AUX screen.

  • JackE
    JackE ACE Posts: 44,891 Trailblazer
    Answer ✓
    There is a BIOS firmware update v1.12 that addresses the black screen issue at this link.


    Jack E/NJ

  • Rene65
    Rene65 Member Posts: 7

    Tinkerer

    JackE you're the man - it worked ! Tx !
  • JackE
    JackE ACE Posts: 44,891 Trailblazer
    Congrats. Thanks for reporting back.  :)

    Jack E/NJ

  • smackycel
    smackycel Member Posts: 3 New User

    Hi @JackE I still don't get blue light from the LED indicator. Any other way?