How do I stop my Hard disk drive from spinning down? Aspire A515-51G

13»

Answers

  • JackE
    JackE ACE Posts: 44,870 Trailblazer
    No. Hdparm still a 32-bit program. However, it has a 32-bit installer for 32-bit Windows machines. And a 64-bit installer for 64-bit Windows machines. Like mentioned earlier, 64-bit Windows machines can easily run 32-bit Windows programs.

    Jack E/NJ

  • per99
    per99 Member Posts: 47 Enthusiast WiFi Icon
    @JackE I hope you have a just as wonderful evening as I !!!  :)  :)  :)  I think I finally understood how to do this – to add "hda" after the 241. 'Cause then i got a "reply" from cmd that is fully understandable. The thing is: This computer is so silent that I can't really tell whether the disk is spinning or not, but I guess we can rely on the information from cmd (?)
  • per99
    per99 Member Posts: 47 Enthusiast WiFi Icon
    *

    But I still would like to know if those 30 minutes does apply even to battery usage. But I guess I will notice, sooner or later.
  • JackE
    JackE ACE Posts: 44,870 Trailblazer
    If the spindown doesn't happen for 30 minutes instead of a shorter time, the battery usage will increase.

    Jack E/NJ

  • per99
    per99 Member Posts: 47 Enthusiast WiFi Icon
    Hello again. Just to be sure it was the right option to write "hda" at the end of the command (according to screenshot april 1, 10:58 pm), I made an experiment and wrote "hdb" instead. I had expected an answer from cmd like: unvalid command. But to my big surprise something new/else does now have an active time of 30 minutes.

    I do have two disks. One solid state (128 GB) and one HDD (1 TB). I guess SSD (C:) is = a, and HDD (D:) is = b. But I really don't know what conclusions to draw now, as to how things may have been altered. Could someone give me some reliable and full-length information about this, please? When i typed hda april 1, it was because I only have one HDD, so therefore I assumed I should call it 'a'.




     
  • JackE
    JackE ACE Posts: 44,870 Trailblazer
    >>>I do have two disks. One solid state (128 GB) and one HDD (1 TB). I guess SSD (C:) is = a, and HDD (D:) is = b.>>>

    Yes if you have 2 disks now and if HDD is  D : \  ,  the linux switch would be /dev/hdb or /dev/sdb . But you must be sure that HDD is D : \ and the SSD is C : \ . You can't guess. You must be sure.

    As I mentioned earlier, if you want more details on how these things work and how to find out which drive is your C : \ and D : \ , you should post your own new thread by clicking on the green ask a question button.


    Jack E/NJ