G195HQV goes black after turning on pc

Paxini
Paxini Member Posts: 3 New User
edited October 2023 in 2020 Archives
Hi, I used G195HQV for like 10 years, in last 3 as a secondary monitor.
In recent times, when the pc boots, it doesn't show picure imediately, the screen is black and the lamp is making a cycle between being off, glowing yellow and glowing blue (every one for about 0,5s), and again and again.
When it first occured, the picture was shown in about 10 seconds after the boot, but now it takes it more than 20 minutes to load.
I wanted to ask, if there is anything I can do to fix that? I understand that the monitor is pretty old, but I want to pull some last days from it before buying another monitor.
Thanks in advance.

My setup:
ASUS ROG nVidia GTX 1050Ti OC
Intel Core i5 8400
8GB ram
Windows 10 Pro 64-bit (10.0, Build 17763)

Best Answer

  • billsey
    billsey ACE Posts: 35,044 Trailblazer
    Answer ✓
    Sorry to say you are likely right. :(
    Click on "Like" if you find my answer useful or click on "Yes" if it answers your question.

Answers

  • billsey
    billsey ACE Posts: 35,044 Trailblazer
    Does the splash screen come up and show correctly when you turn the monitor on? You might have a cable going bad if it's not the monitor itself.
    Click on "Like" if you find my answer useful or click on "Yes" if it answers your question.
  • Paxini
    Paxini Member Posts: 3 New User
    Thanks for answering, @billsey
    Now, monitor isn't working anymore. The no light - yellow light - blue light cycle goes forever, even when PC is turned off. I took a video of it: https://www.youtube.com/watch?v=T1OBayMAlOc&ab_channel=Paxini
    Also, it is connected to graphic card via VGA - VGA cable connected to VGA - DVI adapter.
  • billsey
    billsey ACE Posts: 35,044 Trailblazer
    Try a power reset, disconnect everything from the monitor then press and hold the power button for 30-60 seconds. Release the button and wait a few minutes then plug everything back in. If it's just in a confused sleep state that should clear it up.
    Click on "Like" if you find my answer useful or click on "Yes" if it answers your question.
  • Paxini
    Paxini Member Posts: 3 New User
    billsey said:
    Try a power reset, disconnect everything from the monitor then press and hold the power button for 30-60 seconds. Release the button and wait a few minutes then plug everything back in. If it's just in a confused sleep state that should clear it up.
    Did as you said, didn't work (same happends). I guess it's time for new secondary monitor
  • billsey
    billsey ACE Posts: 35,044 Trailblazer
    Answer ✓
    Sorry to say you are likely right. :(
    Click on "Like" if you find my answer useful or click on "Yes" if it answers your question.