Acer Aspire TC220--- Two beeps and a black screen

Norine
Norine Member Posts: 2 New User
edited March 1 in 2020 Archives
HELP!  Went to use my computer yesterday.... Turned the  power button on. Two beeps and a black screen.  I shut it off... unplugged the cord and removed it from the back of the computer. I took off any USB etc from it... disconnected the keyboard and the mouse etc.  I checked online to find out what the two beeps might mean. A parity issue.  Memory possibly or troubleshoot motherboard.  I plugged it back in and turned it on... two beeps again. I shut it off again. Did this three times... same things happening. So, I took the side panel off and removed the 8GB Memory... put it in the other slot...tried again... same thing. It is the only ROM there is in there. So, now I don't know what to do. DO I assume the thing is bad and get a new one? Or, is there something else I can try. It is very strange and, as the computer is not used a lot, I am at a total loss.  HELP!!! 

Answers

  • laurent_14
    laurent_14 ACE Posts: 10,320 Trailblazer
    Hello,
    You can try this. Out of voltage, you have to remove the RTC battery (silver coin) for a few seconds and put it back again.
    France
  • Norine
    Norine Member Posts: 2 New User
    Thanks so much for your assistance. Could it be that the battery needs replacing?  As you can tell, I am not very knowledgeable about this stuff......That seems like a good place to start re cost of repair/replacement items... 
  • billsey
    billsey ACE Posts: 34,246 Trailblazer
    The beep codes for you system say:
    Two short beeps. CMOS failure • CMOS checksum error
    Very likely the CMOS battery has gone bad. Just swap it out for a new one.
    If instead you are getting a long beep followed by the two short beeps it's a GPU failure and you should try removing and reseating the graphics card.

    Click on "Like" if you find my answer useful or click on "Yes" if it answers your question.