How can I go to recovery mode the other way?

NikkiOrito11 · January 2020

My Netbook was shut down, then t started boot looping, Ive done steps recommended to me but nothing of them worked. My BIOS is insydeh20 setup utility rev 5.0. I turned the D2D recovery on and set the settings to default. Now, I press Alt+f10, it says please wait and after it loads, it goes to a blank screen. It doesnt go to the recovery setting that I needed to go.

Sathish2388 · January 2020

NikkiOrito11.. Hi! Do hard shutdown for 3 to 4 times( turn on your computer and once you get acer logo turn it off).. check whether you are getting preparing automatic repair with advance options..

NikkiOrito11 · January 2020

Sathish2388 said:

NikkiOrito11.. Hi! Do hard shutdown for 3 to 4 times( turn on your computer and once you get acer logo turn it off).. check whether you are getting preparing automatic repair with advance options..

It didnt work, I did some passwords before I boot it in And it wont work doing that way tho. i cant hard shutdown, Is there any other way?

Sathish2388 · January 2020

Is your computer booting in to login page?

NikkiOrito11 · January 2020

Sathish2388 said:

Is your computer booting in to login page?

It is stuck on the acer logo and its boot looping. Whenever I hit alt+f10 it starts to say please wait and it would show me a blank screen afterwards. A total letdown

NikkiOrito11 · January 2020

This is the current situation

after I tried using alt+f10

egydiocoelho · January 2020

What is the exact model? Example A515-51-58VH. Try reset battery?

Sathish2388 · January 2020

-> Turn off your computer and unplug the power cable

-> Flip down your laptop and insert paper clip in battery reset pinhole and hold it down for 10 seconds then release the paperclip

-> connect the power cable then turn on your laptop and get in to bios by tapping f2 key.. press f9 for load defaults then press f10 for save and exit..