Only runs while plugged in to charger. Replaced battery, pinhole reset battery

2»

Answers

  • JackE
    JackE ACE Posts: 44,868 Trailblazer
    OK. Yes, this thread will be accessible even after it's archived. Jack E/NJ

    Jack E/NJ

  • nocharge
    nocharge Member Posts: 13

    Tinkerer

    JackE
    Success!  I installed the new battery (15.2 volt) and its charging! What is embarrassing is I had installed the wrong battery (11.4volt) previously when I had the no charge problem. I had purchased that battery (11.4 volt) from Amazon, it was listed for an Aspire V3-372T-5051, which is my computer. I didn't think much of it when I received it and installed it. It was the same physical size, same (two screw) mounting tabs, same electrical connector, but a lower voltage 11.4 volt instead of the battery I received today which is 15.2 volt. Many thanks to you for your help in determining that the problem indeed was the battery. Next time I will scrutinize the physical and electrical specifications before replacing the suspect part. You were very knowledgeable and helpful, it was informative to do the diagnostics you requested. I am so pleased to get it going, I like this model.  Thanks again!  
  • JackE
    JackE ACE Posts: 44,868 Trailblazer
    Answer ✓
    Congrats on your success. Jack E/NJ

    Jack E/NJ

  • nocharge
    nocharge Member Posts: 13

    Tinkerer

    Thanks again Jack!
  • Silboatto
    Silboatto Member Posts: 1 New User
    I have the same problem, but I cannot find the battery. Where can I find the same battery as Jack
  • JackE
    JackE ACE Posts: 44,868 Trailblazer
    The bottom cover must be removed.

    Jack E/NJ

  • chairlift
    chairlift Member Posts: 1 New User
    Not 100% sure but I think the battery is: 15.2 volt AC14B8K