I have an Acer Iconia 7 b1-730hd one.

ionutz007
ionutz007 Member Posts: 2 New User

I have an Acer Iconia 7 b1-730hd one. a few days, I have a problem, I look like I have 19% battery whether it is loaded or not. what can be done? thank you

«1

Answers

  • IronFly
    IronFly ACE Posts: 18,413 Trailblazer
    Try a factory reset but do a backup of your personal data before.

    Settingd/backup&reset/factory reset

    Or try to charge the battery with tablet powered off if it allows.
    I'm not an Acer employee.
  • ionutz007
    ionutz007 Member Posts: 2 New User

    I gave reset, but is the same, even when the loaded extinguished, no more than a dash, stays there. the idea is that the battery just keeps me just as android does not show accurate battery level.

  • schafferrob
    schafferrob Member Posts: 6 New User
    I have the same problem too. My battery stuck at 2 %. The battery is fine only the counter doesn't change. Don't wanna make a full reset.
  • IronFly
    IronFly ACE Posts: 18,413 Trailblazer

    Contact Acer support service if under warranty.

    I'm not an Acer employee.
  • billsey
    billsey ACE Posts: 34,101 Trailblazer

    schafferrob wrote:
    I have the same problem too. My battery stuck at 2 %. The battery is fine only the counter doesn't change. Don't wanna make a full reset.

    It sounds like an issue with the battery charge calculation, or the battery sensors. I assume by the 'battery is fine' that it runs for quite a while when started with a full, 2%, charge? I agree with Ironfly, best if Acer goes ahead and fixes it for you. If it is the sensors then without a fix they might allow overcharging and would likely not optimize the usage correctly. You don't want an early failure due to faulty sensors...

    Click on "Like" if you find my answer useful or click on "Yes" if it answers your question.
  • schafferrob
    schafferrob Member Posts: 6 New User

    Thank you very much.

    well I did a full reset. The problem still exists. 

    I will try make the battery empty, see what happens. 

  • IronFly
    IronFly ACE Posts: 18,413 Trailblazer

    not a good thing to empty completly the battery.

    can you try to power off and then connect the AC adapter?

     

    let's see if it can charge the battery.

    I'm not an Acer employee.
  • christyo
    christyo Member Posts: 2 New User

    Having the same trouble here at 1% battery.  Any fixes yet?

  • billsey
    billsey ACE Posts: 34,101 Trailblazer

    Will yours also run for sevedral hours at 1% battery with the power supply disconnected?

    Click on "Like" if you find my answer useful or click on "Yes" if it answers your question.
  • christyo
    christyo Member Posts: 2 New User

    I charged it powered on last night and it read 98% battery.  I unplugged charger and turned it off, then turned it back on about 30 minutes later and would not stay on and battery has read 1% ever since.  Sometimes, it will say "plugged in, not charging" while it is powered on and plugged in.  If it is not powered on and charging, it seems to stop charging and when I power on, battery says 1%.  I think it will have to be sent in to be fixed.  I've tried different chargers and cables and a hard reset as well.

  • schafferrob
    schafferrob Member Posts: 6 New User

    I empty the battery and charged with power off the whole night.  Still the same 2℅. 

  • schafferrob
    schafferrob Member Posts: 6 New User
    Now I made some progress. If I empty the battery to zero and put in the charger, then the counter is always changing. Once 10 % than 60% than 35% and so on. And one thing if the tablet is restarted it forgets the wifi password.
  • Cephalu
    Cephalu Member Posts: 3 New User

    I have the same kind of problem on a b1-730. The battery meter is stocked to 47%.

    I have now installe a Battery app and it says that as around 4.3 Volts between

    its contacts.

     

    According to some wikis on lithium batteries this battery should be

    fully charged.

     

    It appears that there is software problem on my tablet.

     

     

  • schafferrob
    schafferrob Member Posts: 6 New User

    Yes I thought so. I've sent the tablet to repair center the end of january.
    They informed me: they will update the software. I hope next week will be ready.
    So if you have the same problem, maybe the update will be available OTA.

  • Cephalu
    Cephalu Member Posts: 3 New User

    Using the Battery application I have monitored manually the battery

    voltage versus time when charging. I obtained the following numbers

    for my Iconia One 7 b1-730.

     

    Elapsed time Voltage

    00:00            3,674

    00:06            3,696

    00:15            3,748

    00:23            3,76

    00:40            3,813

    01:05            3,985

    01:22            4,09

    01:57            4,181

    02:25            4,255

     

    This curve is actually going to have a ceiling at around 4.3 Volts and maybe more.

     

    According to my web research. Charging a Li-ion battery at 4.3 Volts is not

    a good idea. Although it will increase its capacity, il will reduce significaly

    its expected number of recharged cycles perhaps to bellow a few hundred.

     

    When the battery is dead the only thing to do is to send the tablet to

    recycling and buy an other. That is a very well planned obsolescence

    strategy.

     

    If you whan to keep your tablet for a few years guys, you will have to

    recharge that battery manually keeping an eye on the voltage.

     

  • schafferrob
    schafferrob Member Posts: 6 New User

    I have my tablet back after a month. Now it's working fine.

  • Halixman
    Halixman Member Posts: 10 New User

    I have the same problem. My tabley is stuck at 2%. I'm trying to reinstall the OS, not wipe data, I wanna delete all the OS. I think is a software issue.

     

    I downloaded the firmware from the acer web page:

     

    http://global-download.acer.com/GDFiles/OS/OS/OS_Acer_Acer.AV0K0.B1-730.RV01RC01.WW.GEN1_A44K_A.zip?acerid=635567119594638672&Step1=TABLET&Step2=ICONIA ONE 7&Step3=B1-730&OS=ALL&LC=es&BC=ACER&SC=EMEA_11

     

    Copied the zip to an SD Card... restart the tablet with the power button and the volume... select "apply update from an sd" but it shows this:

     

    FAILED TO MOUNT /MNT/SDCARD1 (NO SUCH FILE OR DIRECTORY)

     

    What am I doing wrong?

  • IronFly
    IronFly ACE Posts: 18,413 Trailblazer

    check if microSD is FAT32 formatted.

    I'm not an Acer employee.
  • Halixman
    Halixman Member Posts: 10 New User
    Already checked. Same result. Also I changed the zip name to update.zip
  • IronFly
    IronFly ACE Posts: 18,413 Trailblazer

    have you unzipped the downloaded file?

    I'm not an Acer employee.