Asic Controller 106C Degrees & Stuttering in Nitro AN517-41. Is the temp normal?

Mawiwauii
Mawiwauii Member Posts: 59 Troubleshooter
edited November 8 in Nitro Gaming

ive been having random fps drops and found this, in DRIVE TEMP 3 it says is the ASIC CONTROLLER, is that temp normal?

it says thermal throttling, i have a AN517-41, thats the ssd or like a circuit board it goes?

[Edited the thread to add model number to the title]

Answers

  • eGomes
    eGomes Member Posts: 4,569 Guru

    It's not a good idea to use Samsung PM981a (MZVLB1T0HBLR-00007) without heatsink and poor ventilation. These SSD's tend to get very hot!

    If we look at the PCB layout of the motherboard of the Nitro AN517-41, you can see that the EC chip is very near to the M.2 #2 slot. And this has the potential to trigger the BD-PROCHOT, and consequently cause bottleneck in the system due to the excessive heat generated.

    Perhaps the solution is to use just a single M.2 SSD, or opt for another model recommended by the manufacturer.

    You can also use the Samsung Magician software to check if there are any firmware updates available. However, I think it's unlikely to improve the temperatures you're getting.

  • NghiemPham0404
    NghiemPham0404 Member Posts: 7

    Tinkerer

    edited November 4

    Have you considered using a thermal pad and a light heatsink for your ssd ? The below video link show how to prevent your samsung mvne ssd from overheating with thermal pad

    https://www.youtube.com/watch?v=I8Z09nU554Q

  • Mawiwauii
    Mawiwauii Member Posts: 59 Troubleshooter

    didnt know u can buy a heatsink for ssd, thanks for that video bro, i was about to send it to warranty

  • Mawiwauii
    Mawiwauii Member Posts: 59 Troubleshooter

    do u know if the heatsinks aare all the same or pc desktop are differents from laptops?

  • NghiemPham0404
    NghiemPham0404 Member Posts: 7

    Tinkerer

    it's all about the thickness of the heatsink, you have to choose a slight thinkness heatsink for ssd in laptop. The 0.8- 4.0 mm thickness should fit inside a Nitro 5

  • Mawiwauii
    Mawiwauii Member Posts: 59 Troubleshooter

    thanks broo, i was looking for that