Have predator5000, changed gpu, bleeping like no gpu, monitors don't work

MoSPARKY
MoSPARKY Member Posts: 8 New User

Have an acer predator 5000. I710700k, RTX 2070super. 750w pcu. Have changed the gpu for 4070ti super. Bleeping to say I have no card and monitors don't start so can't change any drivers or settings?

Answers

  • billsey
    billsey ACE Posts: 34,246 Trailblazer

    Which PO 5000 do you have? A 750W PSU should be enough to drive a 4070ti Super. That card does pull more power than a 2070 Super, but not a huge amount more… Are you sure the card is good, and do you have all the extra power cables connected?

    Click on "Like" if you find my answer useful or click on "Yes" if it answers your question.
  • MoSPARKY
    MoSPARKY Member Posts: 8 New User

    Have power cabled correct. PO5-615s. Card is an asus tuf gaming, brand new out box. A friend of mine said I need to update my bios as I never have. Have 3 bios updates available for my PC but have no clue what is for gpu and I'm a bit concerned as it says updating wrong think can damage system?

  • MoSPARKY
    MoSPARKY Member Posts: 8 New User

    Have put old card in a boots up fine

  • MoSPARKY
    MoSPARKY Member Posts: 8 New User

    The 4070ti super lights up and the fans spin on it. Have done power calculation and my whole system is 562w. Also have transferred the whole system into a corsair 7000Dwas a bit tight in old case and wanted more airflow. The case came with 3x140mm fans which I have installed in the front and have the two fans from Mt old case as exhausts in the top back corner. All the fans start up the 3x140 stop after about 5sec. All 5 fans run off same fan plug on motherboard?

  • GotBanned
    GotBanned Member Posts: 654 Seasoned Specialist WiFi Icon
    edited February 19

    I would visit a friend and try the card there. Sometimes these things are DOA.

    What happens if you create a Windows Installation Media on an USB stick and use it to boot? Do you get a picture now? That USB stick should have almost "all" needed drivers on it.

    If you want to be extra careful, remove the SSD where your Windows installation is, so that you won't lose data no matter what happens.

    EDIT: Sometimes the power cable can be pain in the derriere to install properly.

  • billsey
    billsey ACE Posts: 34,246 Trailblazer

    Yes, I don't see anything that would cause the problem other than a bad card. That slot is a standard PCIe 3.0 x16 slot, so nothing special required. I don't see any hints that a BIOS update will change anything… All the updates so far have just been the typical microengine security fixes.

    Click on "Like" if you find my answer useful or click on "Yes" if it answers your question.