Recommended thermal pad thickness for acer aspire 5 A515-54G.

TROJAN
TROJAN Member Posts: 2 New User
I recently opened my aspire 5 a515-54g mx 250, i5 8th gen to clean up the fans and replace thermal applications and was confused what thickness of thermal pads are required for the two vrms and also suggest a brand with amazon link.
Thank you

Answers

  • JackE
    JackE ACE Posts: 45,081 Trailblazer
    You should instead paste with either Kryonaut or ArcticMX4. If you however insist on using a pad, the ACER recommended part is Eapus  XR-PE but the pastes are superior. Jack E/NJ
      

    Jack E/NJ

  • TROJAN
    TROJAN Member Posts: 2 New User
    JackE said:
    You should instead paste with either Kryonaut or ArcticMX4. If you however insist on using a pad, the ACER recommended part is Eapus  XR-PE but the pastes are superior. Jack E/NJ
      

    yeah but vrms are supposed to be cooled with thermal pads right? as a substitute I placed thermal paste till the pads arrive but performance seems bit low maybe because it should be thermal pads. By low i mean i cleaned it before but left the "melted pads" and got a good improvement this time the improvement is low after i cleaned the melted pads and and placed thermal paste on vrms.
  • JackE
    JackE ACE Posts: 45,081 Trailblazer
    >>>yeah but vrms are supposed to be cooled with thermal pads right? >>>

    No. Can use either. The recommended Kryonaut & ArcticMX4 pastes are superior. Jack E/NJ




    Jack E/NJ

  • Vrgms
    Vrgms Member Posts: 3 New User
    edited December 2022
    • When I opened the acer 515-54g with mx250 I ended up removing that pink thermal paste from the vrams, at the time I didn't notice that it has a different thickness than the standard thermal pastes. I applied thermal paste on top of the 2 vram chips, is it having contact with the heatsink? or would it have to be some thicker thermal pad


  • JackE
    JackE ACE Posts: 45,081 Trailblazer

    Vrgms

    This is an old thread. For better attention, click the green ask a question button in upper right hand corner of page to start your own new thread.

    Jack E/NJ