P05 640 Noctura question.

Jimkelly1
Jimkelly1 Member Posts: 26 Enthusiast WiFi Icon

Do you need to remove the motherboard to install it?

Best Answers

Answers

  • Which cooler do you have? Have a look at your Noctua manual as that shows and has a video on the appropriate way to install whatever Noctua cpu cooler you have.

  • billsey
    billsey ACE Posts: 34,682 Trailblazer
    Answer ✓

    The Noctua model that everyone recommends here doesn't require removing the motherboard. That's one of the big pluses for it...

    Click on "Like" if you find my answer useful or click on "Yes" if it answers your question.
  • Jimkelly1
    Jimkelly1 Member Posts: 26 Enthusiast WiFi Icon

    So I have the PO5-640-UB11 and I ordered the Noctura nh-u9s and it looks like to have to remove the motherboard, Even though the h660 motherboard has a stock retention model I the screws that come with cooler wont allow for set up unless I'm missing something.

  • StevenGen
    StevenGen ACE Posts: 12,515 Trailblazer
    Answer ✓

    It's a simple job to take the PO5-640 mobo out, dissasemble all the appropriate components pre taking the mobo out and undo the mobo screws that are shown below and then follow the Noctua NH-U9S installation guide.


  • Jimkelly1
    Jimkelly1 Member Posts: 26 Enthusiast WiFi Icon

    Update

    I ended up breaking the post on the cpu bracket so I had to remove the mb. Installed the bracket that came with the cooler and finally got it back together. Wasn't that difficult but the 12mm screws were to long.

  • billsey
    billsey ACE Posts: 34,682 Trailblazer

    You shouldn't have needed to remove the MB, just use the spacers and screws with the stock brackets.

    Click on "Like" if you find my answer useful or click on "Yes" if it answers your question.
  • Jimkelly1
    Jimkelly1 Member Posts: 26 Enthusiast WiFi Icon

    The kit doesn't come with the correct screws for 1700 boards

  • chugzilla
    chugzilla Member Posts: 730 Seasoned Specialist WiFi Icon

    yeah every video on it shows no matter what model u get you need to replace the backplate... ive been doing some research on it...was thinking of getting the dual fan one in black...i emailed them with all my details and specs ill let ya know what they say

  • billsey
    billsey ACE Posts: 34,682 Trailblazer

    I wonder if they just didn't have the new version in stock? They made changes to the NH-U9S when the 1700 sockets came out to support the slight size difference... You might have gotten the old kit.

    Click on "Like" if you find my answer useful or click on "Yes" if it answers your question.
  • Jobu
    Jobu Member Posts: 7

    Tinkerer

    I have the P03-630 and purchased the Noctua NH-U9S. I had to remove the mb to install the backplate. In addition, the screw holes on the back plate did not match up with the holes on the mb by a few mm so had to drill those out to make it fit. It was a hassle but worth it in the end.