Aspire M3802 rebuild problems

mickq
mickq Member Posts: 1 New User

I have replaced the PSU and on start I get the usual one short beep followed about 10 seconds later by two short beeps. Nothing on monitor. Suggestions? Thanks

Answers

  • Juzzo
    Juzzo Member Posts: 117 Troubleshooter

    What was the Wattage on the old PSU? Wattage on the new?

    Was the PSU replaced due to the old one going out? Or was it as an upgrade (Perhaps a new GFX card)?
    (If you installed a new GFX card, and didnt match (or go bigger) the wattage, the new card will not work)

    Please ensure that you have run power to your hard-drive, and any GFX cards you have installed (Wouldent hurt to double check all connections, however those two would be the first I checked).

    Should have a big 20 or 24 pin line to the motherboard, and more than likely another 4 pin elsewhere (Lots of folk miss the second one).

This discussion has been closed.