An515 45 r55p

Yohanmiks
Yohanmiks Member Posts: 1 Newbie

My laptop nitro 5 An515 45 r55p just suddenly turn off I just thought at first it's low battery but the indicator of charging or battery it doesn't light up I tried the pressing the power button method removing all plug in the laptop

Answers

  • StevenGen
    StevenGen ACE Posts: 14,402 Trailblazer

    Your Nitro AN515-45 is a 5 years old laptop and the first thing that you should look at and change is its oem Acer fitted battery, as these laptops batteries discharge and recharge properly between 3-4 years before they can start to cause problems of the laptop not charging and/or failing to boot.

    Buy this battery if your battery is faulty

    image.png

    Otherwise your AN515-45 has a frozen EC, Chipset or a bios chips and they need to be reset, so you need to do a Hard Reset like the guide shows below, as this should make your laptop boot correctly, if not, then your laptop either has faulty and shorted power rail or at worst a burnt cpu which if that happens you need a new mainboard. so if the hard reset doesn't work, i suggest that you take your AN515-45 laptop to a technician so that they can pinpoint the fault and fix it. Good luck.

    Hard Reset - Remove the eleven (11) screws from the base cover to the upper case of your Nitro AN515-45 laptop, starting from the upper side, pry to release the upper side latches, continue releasing the remaining latches. Then remove the lower case.

    Press the power key for 10 seconds to release all power to the laptop and then disconnect the main battery cable from the mainboard, then take the main battery out. Then disconnect the RTC/BIOS battery and then short the bios batteries + & - pins at the mainboard plug (as shown at the circled plug below) to reset CMOS and then take all the ran out.

    image.png

    Leave the laptop like that for at least 30 to 60min so that EC and Chipset chips reset completely and then reconnect everything, if you have 2x ram modules, only connect 1x ram module and alternate the two ram modules and see if its not the ram that is faulty and causing the none boot, as the laptop should turn on and boot properly with an image on the screen.

    If this answers your question and solved your query please "Click on Yes" or "Click on Like" if you find my answer useful👍