Is it possible to run 2 x16GB Kensington fury DDR5 5600mhz in Acer Predator 3000 PO3-655 with XMP?

Gunite82
Gunite82 Member Posts: 9

Tinkerer
edited October 1 in Predator Desktops

Hi.

I was just wondering if it was possible to run 2 x16GB Kensington fury DDR5 5600mhz in my Acer Predator 3000 PO3-655 with the XMP enabled?

I was given by my brother and installed them in the recommended A1 & A2 slots as recommended in the Acer Ram Install guide, I found but no matter which way i Install them I can't get the Bios to load the Memory Section in the advanced Bios screen.

I guessing the Motherboard doesn't allow XMP but thought I would check here before I give up and live with them as is.

Thanks for any advice in advance.

[Edited the thread to add model number to the title and add issue detail]

Answers

  • Puraw
    Puraw ACE, Member Posts: 13,422 Trailblazer
    https://community.acer.com/en/discussion/713413/xmp-ram

    Hi, the Acer Predator Orion 3000 PO3-655 does support RAM with XMP (Extreme Memory Profile), BIOS does not allow you to overclock your RAM for better performance.

  • billsey
    billsey ACE Posts: 34,246 Trailblazer

    Also, the default speed used in the PO3-655 is 5600, so those should run at full speed, no need for overclocking.

    Click on "Like" if you find my answer useful or click on "Yes" if it answers your question.
  • Gunite82
    Gunite82 Member Posts: 9

    Tinkerer

    I thought the same when i installed it @billsey but it appears to only be running at 4400MT/s still.

    memory screen shot.png

  • billsey
    billsey ACE Posts: 34,246 Trailblazer

    What speed did the stock memory run at, and what memory was installed from the factory?

    Click on "Like" if you find my answer useful or click on "Yes" if it answers your question.

Categories