can i Upgrade case for PO3-640

zangetsu191991

Hello everyone, I am new to the forum and hope I have written in the appropriate section.
I would kindly need your advice as you are surely more experienced than me.
I've read around and on various forums that motherboard PO3 640 doesn't have a standard form factor and this makes it difficult to see what other cases it can be installed in. Unfortunately the small size of the case doesn't allow for many upgrades, so I was wondering ifwas it possible to move it there in an NZTX H9 Flow case?

Thanks in advance to those who will answer me.

[Edited the thread to add issue detail]

billsey

Yes, the DTX and micro-ATX (uATX) use the same mount points. As stated before though, you will likely lose access to those front ports you have now with the stock case.

billsey

Any case that supports a DTX or uATX form factor motherboard will work, but you will lose access to those front ports, since they will expect that you be able to use cables for them instead of having them directly tied to the MB.

zangetsu191991

https://community.acer.com/en/discussion/comment/1245408#Comment_1245408

Thank you very much for your reply,
in the NZTX H9 Flow case manual I would see this as supported shapes for the motherboard:

So it should be compatible with the PO3-640 motherboard, right?

billsey

Yes, the DTX and micro-ATX (uATX) use the same mount points. As stated before though, you will likely lose access to those front ports you have now with the stock case.

zangetsu191991

https://community.acer.com/en/discussion/comment/1245586#Comment_1245586

great, thank you very much for the valuable information you have provided me.