My ASPIRE 3 WON'T START

Henilmaniya123
Henilmaniya123 Member Posts: 34

Tinkerer

edited October 2021 in Aspire Laptops
I press power button in my leptop after this process the power LED light is Blue on and Automatically off and again on and off and this loop was infinite but doesn't show display how can I fix not show black screen screen is off and power LED light is Automatically on and off again on and Automatically off  :(

Answers

  • Tachi13
    Tachi13 Member Posts: 135 Skilled Fixer WiFi Icon
     Henilmaniya123 said:
    I press power button in my leptop after this process the power LED light is Blue on and Automatically off and again on and off and this loop was infinite but doesn't show display how can I fix not show black screen screen is off and power LED light is Automatically on and off again on and Automatically off  :(
    Is this how your screen looks or is it because of the phone's camera? This seems like an LCD panel issue. Normally, you if the blue light for power (Bulb) is lit, it means it is powered on. You may have to send it for repair, it should be covered under warranty if it is in warranty, and not damaged.
    Please click on "Yes" if you find this answer helpful. :):)
  • Jack22
    Jack22 ACE Posts: 4,167 Pathfinder
    @Henilmaniya123
    Turn off the unit by pressing the power button for 30 seconds. Once all the light goes off, remove the charger if it is connected.
    Look at the back of the laptop and you can find tiny pin hole with a battery symbol. Get a paper clip or needle put it inside the pin hole and press and hold it for 30 seconds.
    Than try to turn on.
    Click on 'Yes' if the comment answers your question!
  • Easwar
    Easwar Member Posts: 6,727 Guru
    Henilmaniya123,

    # Try to get the BIOS page.
    1. Turn OFF the unit.
    ​2. Press and hold the F2 key and turn on the unit. 
    3. You will be in setup utility page. 
    4. Once you got the screen release the F2 key.
    5. Tap on F9 key and hit enter key without changing the option.
    6. Tap on F10 key and hit enter key without changing the option.
    7. Your unit will restart by itself. 

    Check this T/S and post the result. ​