Acer Nitro 5 An515-53 Battery not detected after unplugging power unit and plugging it back in

ShangWang
ShangWang Member Posts: 186 Mr. Fixit WiFi Icon
Hi all,

I decided to open up my laptop to re-paste my heat sink. I did all the proper procedures and made sure to unplug the power unit CAREFULLY before proceeding to remove the heat sink, clean the old paste, and then reapply the new paste and screwing back in the heat sink.

I then plug back in the power supply, making sure it clicked and pushed it further in to make sure it's in there.

I screwed everything back in, and my laptop wont turn on unless it's charged.
I shutdown my laptop and attempted to use the battery reset pin hole, still nothing. Tried uninstalling the ACPI and scanning for hardware changes, nothing. Troubleshooting, nothing.

My laptop only turns on the instant I plug in my laptop, it works but the light with the battery icon does not show up, so my battery is not recognized and not being charged at all.

I've never had any battery problems until I unplugged the power supply and plugged it back in, I made sure not to damage anything by tugging on the cables.

Does anyone know any other solutions that may work?


Best Answer

  • ShangWang
    ShangWang Member Posts: 186 Mr. Fixit WiFi Icon
    Answer ✓
    Apologies disregard, I just did not push the power cable in enough, it's working fine now!

Answers

  • ShangWang
    ShangWang Member Posts: 186 Mr. Fixit WiFi Icon
    Answer ✓
    Apologies disregard, I just did not push the power cable in enough, it's working fine now!
This discussion has been closed.