Acer Display Widget

System
System Member Posts: 4,566 Seasoned Practitioner WiFi Icon
edited February 27 in 2020 Archives
This discussion was created from comments split from: Acer Display Widget.

Answers

  • EdCrins1910
    EdCrins1910 Member Posts: 3 New User
    edited September 2020
    Nikiloas said:
    This program manages display profiles and divides the screen into work areas. When you turn on the computer, the application starts automatically and is displayed on the screen until you minimize it. In addition, each time after launching the application, it is required to open the Split Screen settings tab, tick “ON” in it to enable the corresponding function (screen division) and then select the “monitor division profile”. Moreover, the selected profile is saved by the program only until the reboot (while the settings in other tabs are saved, but there are no settings in the Split Screet). Actually, it’s going to complete this quest with EVERY computer turned on. It is very inconvenient and tiring. I think this is not a normal software operation, given that this monitor costs almost 80k. Question to you, how to support. How to make the application save the selected Split Screen profile, do not require it to be activated each time, and when it starts, it automatically minimizes to tray.
    ***************************************************************************************************************************************************
     Experienced same problem. After some time the Acer Display Widget stops working suddenly. The application has be maximzed again and the ON mode has to be manually swithed on. What could be the cause of this behavior ? I am working with a Dell laptop in combination with an Acer E491CR wide screen. Looking for help / suggestions ?????????
    ****************************************************************************************************************************************************
  • EdCrins1910
    EdCrins1910 Member Posts: 3 New User
    edited September 2020
    Nikiloas said:
    This program manages display profiles and divides the screen into work areas. When you turn on the computer, the application starts automatically and is displayed on the screen until you minimize it. In addition, each time after launching the application, it is required to open the Split Screen settings tab, tick “ON” in it to enable the corresponding function (screen division) and then select the “monitor division profile”. Moreover, the selected profile is saved by the program only until the reboot (while the settings in other tabs are saved, but there are no settings in the Split Screet). Actually, it’s going to complete this quest with EVERY computer turned on. It is very inconvenient and tiring. I think this is not a normal software operation, given that this monitor costs almost 80k. Question to you, how to support. How to make the application save the selected Split Screen profile, do not require it to be activated each time, and when it starts, it automatically minimizes to tray.
    ******************************************************************************************************************************************************
    Acer Development team, please fix this issue. Choosen settings should be saved. Once the computer is restarted these settings should be reactivated. Minor change I presume.
    ******************************************************************************************************************************************************
  • billsey
    billsey ACE Posts: 34,682 Trailblazer
    Unfortunately this is a community support board and doesn't have any connection to Acer engineers. Contact Acer support and see if they can send the suggestion up the chain.
    Click on "Like" if you find my answer useful or click on "Yes" if it answers your question.