Do RAID 0 settings remain if the hard drives are replaced? predator trident 900

Morldore
Morldore Member Posts: 1 New User
edited November 2023 in 2020 Archives
I recently bought a predator trident 900, and while I don't have a problem with RAID 0 per se I would like to have some peace of mind if one of the drives happens to fail. With no options in BIOS for the onboard raid controller, what I want to know is; if the drives are replaced will the RAID 0 configuration still apply?
To be clear, if for whatever reason I need to replace the drives, I'll probably be upgrading to a larger capacity. Possibly even a different make and model drive. Having little to no experience actually setting up RAID arrays, I want to make sure that the new drives would still be recognized as a RAID 0 configuration without any further interference on my part. After which, all I would have to do is restore the original image to the new hard drives.
While RAID 0 configuration is inherently risky, I'm willing to take that risk and do not wish to convert to any other configurations. Any information on this would be greatly appreciated. Thank you.

Thread was edited to add model name to the title

Answers

  • StevenGen
    StevenGen ACE Posts: 12,839 Trailblazer
    edited September 2020
    Morldore said:
    I recently bought a predator trident 900, and while I don't have a problem with RAID 0 per se I would like to have some peace of mind if one of the drives happens to fail. With no options in BIOS for the onboard raid controller, what I want to know is; if the drives are replaced will the RAID 0 configuration still apply?
    To be clear, if for whatever reason I need to replace the drives, I'll probably be upgrading to a larger capacity. Possibly even a different make and model drive. Having little to no experience actually setting up RAID arrays, I want to make sure that the new drives would still be recognized as a RAID 0 configuration without any further interference on my part. After which, all I would have to do is restore the original image to the new hard drives.
    While RAID 0 configuration is inherently risky, I'm willing to take that risk and do not wish to convert to any other configurations. Any information on this would be greatly appreciated. Thank you.

    First of all its quite a complicated process to do and you do have to have some knowledge, as Raid is not just a matter of backing up and restoring! I can only advise you if you are using “Acronis True Image 2021” or past Acronis versions as that is what I have experience with and have backed u Raid 0 with and did an image restore for Raid 0!

    To do an image Raid 0 restore do the following: 

    -Power down the system
    -Remove my current array and note their orientation, connected to which SATA port, etc.
    -Install your new drives
    -Start the machine, enter the RAID Configuration Utility by pressing Ctrl+M or Ctrl+I (Do not boot into windows)

    -Mark the drive as RAID members
    -Choose your stripe size
    -Create the array
    -Save and exit

    There are only two things that will happen next:
    -Either your system will reset completely and POST... in which case I'd enter BIOS and confirm boot order looks good or (more likely) windows will start
    -Visit Disk Management and see what you've got there
    -You should have an unformatted array

    All you want is an array that appears as a single disk

    Get your Acronis bootable media USB and your back up image ready

    -Restart computer from your Acronis bootable media, select restore

    -Single partition - restore the entire partition

    -Extend it to the full size of the disk or desired size of the partition you want to create
    -If the drive has multiple partitions, restore the partitions one at a time sequentially making each partition the size you want

    Note: see here for instructions on Creating Acronis bootable media: https://www.acronis.com/en-us/support/documentation/ATI2020/index.html#26974.html)