Question about xb273kgp monitor And connecting to my Nvidia GeForce RTX 2080 SUPER

Guitarboarder
Guitarboarder Member Posts: 3 New User
edited February 14 in 2020 Archives

Trying to set up 4K/144hz using Two DP cables as specified in the manual. Here’s the issue:

So, when I would plug in two cables to the back of my GEFORCE 2080 SUPER’s display ports I would get a super “zoomed in” looking display which basically put the start menu and anything else out of my mouses reach. I had to start in safe mode to delete the graphics driver, and restart. This seemed to fix the issue and after restarting and logging into windows normally I was running at 4K/ 144hz. This seemed to be the end of the problem, until I reinstalled the newest driver from Nvidia. After it installed and restarted the machine to complete the install, I was back to a super wide field of view again. I went through this process 3 x before I restarted windows a 4th time without deleting the drivers and starting over. And when I signed in, all appeared well. 

So, my final question is, am I getting these results because the order of display ports aren’t matching up? Does it even matter? 

 Ie: DP1 input connected to DP1 output on the graphics card, and DP2 input connected to DP2 output on the graphics card?

if it DOES matter, does anyone know the order of priority on my graphics card? Nvidia GeForce RTX 2080 SUPER? There doesn’t appear to be a clear distinction made in the manual, just that there are a total of 3 available...thanks for any help!