Acer XZ35 randonsly turns off

Bubbanski
Bubbanski Member Posts: 2 New User
edited February 2024 in 2018 Archives
I mean turns off completely. Blue indicator light turns off. After 2 second the monitor comes back on. It will do this a few times sometimes and other times it won’t do it at all. Then it will start to do it again. I have other monitors that have done this same thing from other companies using different pcs. I’m starting to wonder if there is something wrong with the power in my house. Any ideas?

Answers

  • billsey
    billsey ACE Posts: 34,984 Trailblazer
    It could easily be a power problem in your house, voltage that drops below a limit will disengage the power supply. A work-around would be a UPS that would take up the slack (any many will show you the input voltage over time graph) but the real fix is to deal with the house wiring. Poor wiring could as easily cause a fire instead of just turning the monitor off!
    Click on "Like" if you find my answer useful or click on "Yes" if it answers your question.
  • Bubbanski
    Bubbanski Member Posts: 2 New User
    This house is only 10 years old and I wouldn’t think the wiring would be that bad but it’s a better idea than this new monitor being defective. In the room where the monitor is plugged in there are 6 outlets. 3 of these outlets have major electronics and appliances plugged into them. 2 of these 3 have 2 surge protectors with 6 plugs all taken by an electronic. Would you say this is to much for this one room? Even to much for this one house? Why is that only my monitors over the years show this strain and nothing else?
  • billsey
    billsey ACE Posts: 34,984 Trailblazer
    There's a product called Kill-a-Watt that will monitor the power through an outlet, they're only $20-25 and would tell you for sure if the supply power is your issue. What are the appliances connected in the room? The six outlets may all be on the same circuit and they may have multiple circuits serving them. It depends on what the original usage was supposed to be and the electrician who wired the house. 10 years old means the wiring should be close to code, but if the appliances weren't planned for you might be overloading the standard 10A breaker.

    Click on "Like" if you find my answer useful or click on "Yes" if it answers your question.