ssd on aspire 1410

nakulm
nakulm Member Posts: 2 New User

My ssd is not being recognized, I get boot device not found.

1) I have the Sandisk SDSSDX-120G-G25 (120GB Sata III 6gbps ssd)

2) Imaged it from the hard drive using EaseUS Partition Master 9.2.1. Home Edition (Copy partition) using a usb external drive enclosure for the SSD.

3) Removed currend hd (320GB sata drive) and installed SSD; I did notice the flimsy plastic connecter which I initially pulled off completely, but carefully re-instered the end that goes to the back of the netbook.

4) Boot again - gives no boot device found.

What am I doing wrong. I did confirm multiple times that the sata connecter is attached to the netbook. I carefully removed the ssd and replaced the original drive and everything is booting ok etc. So the connector is not an issue. 

I did not go into the BIOS; is anything further needed to configure the ssd to be used for the netbook. Is the SATA III interface supported?

 

I did confirm that the ssd is ok - re-inserted it into the USB 3.0 external drive and it is able to read and write ok. However I have no way to confirm it is bootable ok.

 

Update:

I entered the BIOS (F2); Boot shows IDE0:  Sandisk SDSSDX120GG25

On exit gives this during boot

For Atheros PCIE Ethernet Controller v2.0.0.9(05/08/09)

Check cable connection!

PXE-M0F: Exiting Intel PXE ROM.

No bootable device - insert book disk and press any key

 

Update2:

Ok, the correct way to copy data is to use EaseUS Backup Not PartionMaster (Clone disk - actually clone partion option). I redid the copy, same result.

Thanks,

Nakul

This discussion has been closed.