G235H shows "No signal" when using DVI but works using fine using VGA

skistar002
skistar002 Member Posts: 1 New User

I have two G235H monitors. One is working fine using a DVI cable to my R9 380 graphics card. However, when I tried to plug in the other G235H using a DVI cable, the screen says that there is no signal. The computer does not recognize the monitor and then the monitor goes into standby mode. I can't adjust the monitor settings either. I swapped the DVI cables and the power cables and one monitor works fine and the other doesn't work. The VGA output on the bad monitor works, which makes me think there is a problem with the DVI connection.

 

Does anyone have any ideas?

 

Thank you.