Ans: 要規劃RAID 50, 至少要有6顆硬碟
Please follow the procedures below.
a. To start the RAID BIOS utility, please press CTRL-H during POST
b. After POST finished, the Adapter Selection page will display on the screen. Click on Start to launch the
configuration menu
c. Please select Adapter Properties to set Factory Defaults from No to Yes, and then click on submit.
d. Reboot the server and then enter the RAID BIOS Utility again by pressing CTRL-H during POST
e. Launch the configuration menu.
f. Select Configuration Wizard
g. Select Add Configuration (default) and click on Next.
h. Select Manual Configuration (default) and click on Next.
i. Select 3 drives with Ctrl key held and click on Add to Array and Accept DG to add these drives into Drive
Gruop0.
j. Select other 3 drives with Ctrl key held and click on Add to Array and Accept DG to add these drives into
Drive Gruop1.
k. After you creating Disk Groups, click on Next.
l. Add both Drive Group0 and Drive Group1 to Span and click on Next.
m. The RAID 10 will be available in RAID Level. Select the RAID Level as RAID 50 and click on Next.
n. Click on Accept and Yes to save the configuration.
o. Click on Yes to initialize the new logical drives. You will see all the logical drives listed.
p. Click on Home to go back to the configuration menu.
q. In the Logic View field, you can see the Spanned Drive Group: 0, RAID 50 listed.
r. Now you can reboot the system and install the Operating System. Select Exit, click on Yes and press
Ctrl+Alt+Del to reboot the system.