Configuring the onboard SATA RAID(BIOS先Load default)
1. Power on the server to start the system POST (Power On Self Test) process. During bootup, press to enter the BIOS setup screen.
2. Press to load BIOS default setting and press save the configuration changes and exit setup.
Enable onboard SATA RAID function (BIOS內開啟onboard SATA RAID功能)
1. In the BIOS Setup Utility, move cursor to . Then select and press Enter.
2. Move cursor to Configure SATA as and press Enter to change the Options to [RAID]
3. Press save the configuration changes and exit setup.
Enter the onboard SATA RAID Configuration Utility(開啟SATA RAID 功能後可進
入SATA RAID Configuration)
When you see the Intel Embedded Server RAID information shows on the screen during the POST (Power-On Self Test), press + to enter the Embedded RAID Configuration Utility.
Loading onboard SATA RAID default setting
1. Select Objects from Management menu.
2. Select Adapter from Objects. The selectable adapter will be listed.
3. Press Enter on the adapter and the adapter setting will be shown
on the screen. You can change the setting from this menu.
4. Select Factory Default and YES to load the default settings.
5. Exit the configuration utility and press + + to reboot the server.
Create RAID 1 volume (建立RAID 1 )
1. Select Configuration from Management Menu.
2. Select New Configuration from the Configuration menu and select
YES to continue. An array selection window displays the
devices connected to the current controller.
3. Press the arrow keys to choose specific physical drives
4. Add 2 drives to current array and press to finish
creating current array.
5. Press Enter again to select array to configure.
6. Press spacebar to select the array and press to configure
the logical drive
7. The default RAID level for 2 disk drives is RAID1. Just select Accept
to use the default setting and press to return to the
ARRAY SELECTION MENU.
8. Press to end the array configuration.
9. Select YES to Save Configuration and press any key to return to
the Configure menu.
Initial RAID Volume(建完RAID後要記得做Initial)
1. Press to return to the Management Menu.
2. Select Initialize from Management menu. All logical drives should
be listed under Logical Drives.
3. Press to select drives for initialization. The selected
drive will be shown in yellow.
4. After selecting the drives, press and select YES to start
the initialization process.
5. When initialization is complete, press any key to continue.
6. Press to return to the Management Menu.
Save and Exit Embedded RAID Configuration Utility (Initial完存檔離開)
1. When RAID configuration and initialization is complete, press
in the Management Menu and select YES to exit the
Embedded RAID Configuration Utility.
2. Press + + to reboot the server.
3. Now you can start to install OS.
4.安裝作業系統前,請先利用Resource CD將WINDOWS SATA Driver建立在磁片
中待用
5.安裝windows時,第一個畫面請先按F6 安裝磁片的驅動程式!
