dlharr

Tinkerer

Comments

  • At the time I bought my cable it was available from Amazon. It did not solve my problem because my original cable was not actually damaged.
  • I was actually thinking about other software like budget, document, spreadsheet, scanner etc Also the EDID thing sounds like the screen might have a chip that got messed up? Maybe that can be rewritten. Does factory reset do that too?
  • The bios version is 1.10 I don't know how to check the EDID. What should the Acer screen be called? I see BOE088BC, HWP3124, and MS_0001. The external monitor connected right now is an hp E241i
  • Any suggestions for how to make it the easiest to get everything (installed software) loaded back up after.
  • I would have to buy a replacement screen. Since they are expensive, if it doesn't work I would like to return it. I don't want to risk marring it during disassembly if I completely assemble it. As I have said before I really don't think that it is a hardware problem, but until it's ruled out I can't get anyone to make any…
  • The cable finally came. Changed it out. Still no difference. Anyone got any other things I can try? Some software setting we haven't checked. If the only thing left to try is the screen, can I hook up the cable and trying it before completely reassembling. I would like to keep the case opening to a minimum and also if it…
  • egydiocoelho, No, the screen is still black no matter how I shine the flashlight. billsey, Sounds like the screen is the most likely candidate. I was not moving it at the time. It rarely got opened more than 100 degrees. Mostly used just once a week so no a lot of reps on the screen open/close. JackE, billsey, I get it.…
  • So you think that while I was rapidly clicking through pictures (not touching the screen) the cable failed which locked up the computer and froze the screen. Then when I forced a shutdown and Rebooted I got the black screen. I'm not as techy as I used to be, can this cable cause that type of behavior.
  • I opened up the laptop. Everything looked really good. No pinched or rubbed cable. I disconnected and reconnected both ends of the video cable. Screen still black. Put everything back together. Hoping the tape and routing will hold as good as before. I tried the disconnect both batteries as well since the case was open. No…
  • Thanks for your advice. I am reluctant to open up the machine. I would like to confirm all software items are correct first. Before I got errors about the BIOS. Today when I went to try it again to make sure I had the full message it worked. Now I have latest Bios 1.10. How can I confirm I have drivers all correct. In…
  • All modes from F5 just show on the external monitor. F6 appears to have no effect.
Avatar