SingeMagique New User

Comments

  • If it helps here is a 9 segment delta luminance I captured from my panel with my i1Display pro. A little loss at the top, but not too bad.
  • Yeah someone brought this up on reddit a few weeks ago. 120Hz ULMB appears to work on both of my XB270HUs (April 2015 manufacture date). Tested with the Blurbusters UFO test. I can definitely tell a difference and there is a noticeable decrease in brightness with ULMB enabled. 
  • Were you able to successfully reset your monitor using either the button combination or the OSD reset option?
  • So it's taken me a while to post back as work and school got incredibly busy for a while. I can reproduce the problem by using iProfiler in ADC mode. It has to be either a problem with the DDC, a firmware issue on the monitor, or perhaps faulty cables. I'm not sure and don't have methods of testing the possibilities. That…
  • Thought I would update you on this. Another thing I noted was that I was only getting the test colors (alternating full screen red, blue, green, black, white) when the display wasn't getting a signal. This would happen if my computer was not turned on, or if I disconnected the DP cable. In the same conditions my working…
  • Yep, I use an i1Display Pro. I also noticed the same odd behavior when setting rgb and all values get set to zero. When I used ADC the faulty panel actually has contrast that always get set to 0. Manually adjusting settings seems to work okay. First monitor I have seen have a problem with ADC. I will try calibrating my…
  • I just received two XB270HU panels this afternoon and one of them is exhibiting this same odd behavior. It doesn't seem to store any of my calibration settings after it has been turned off (front bottom right power button) for an extended period of time. Just as the OP describes here, when I turn the monitor on it seems to…
Avatar