730 Power supply enough for rtx3090?

SharoFF
SharoFF Member Posts: 13

Tinkerer
edited February 15 in 2020 Archives
Got this configuration, 
https://www.acer.com/datasheets/2019/4871/PredatorPO9-600/DG.E16EQ.006.html

Do you think I still need to go for a 850W PSU, or would the one in the system work? 


Answers

  • billsey
    billsey ACE Posts: 34,101 Trailblazer
    It's going to be tight, NVIDIA says 750W and you're at 730W. Likely it'll be fine unless you have the memory fully populated...
    Click on "Like" if you find my answer useful or click on "Yes" if it answers your question.
  • SharoFF
    SharoFF Member Posts: 13

    Tinkerer
    Billsey thanks! =) 

    Do you know if I can find somewhere about information on which memomy is supported by this motherboard, have in this system? 

    I have a spare pc, from where I will switch my PSU to 850W, but also 32Gb of Trident Z memory sticks, which could make a decent upgrade, I believe.


    G.Skill TridentZ DDR4-3600 C16 DC SR - 16GB (2 x 8) x 2

    Hukommelse (RAM), 16 GB: 2 x 8 GB (Dual Channel), DIMM 288-pin, DDR4, 3600 MHz / PC4-28800, CL16-16-16-36, 1.35 V, not buffed.

  • billsey
    billsey ACE Posts: 34,101 Trailblazer
    Spec says anything over 2666 will run at 2666, so paying extra for faster memory will not give you any boost. You can put up to four DIMMs in, up to 16GB each, so maximum memory is 64GB. The only caveat is to make sure you install memory in matched pairs, so you get the advantage of dual channel.
    Click on "Like" if you find my answer useful or click on "Yes" if it answers your question.

Categories