I installed a 2nd SSD that has been working well for months. I turned on the computer today and the 2nd drive is no longer detected.
I ran HWiNFO64 and it says that SATA Host Controller has 1 port and Port 0 is the only port implemented. Is that right? Shouldn't there be 2 SATA ports?
I've pasted the HWiNFO64 output for the SATA controller below.
Help, please.
Intel Gemini Lake SoC - SATA Controller -----------------------------------
[General Information]
Device Name: Intel Gemini Lake SoC - SATA Controller
Original Device Name: Intel Gemini Lake SoC - SATA Controller
Device Class: SATA AHCI Controller
Revision ID: 3
PCI Address (Bus:Device:Function) Number: 0:18:0
PCI Latency Timer: 0
Hardware ID: PCI\VEN_8086&DEV_31E3&SUBSYS_126A1025&REV_03
[System Resources]
Interrupt Line: N/A
Interrupt Pin: INTA#
Memory Base Address 0 A1118000
Memory Base Address 1 A1121000
I/O Base Address 2 1080
I/O Base Address 3 1088
I/O Base Address 4 1060
Memory Base Address 5 A111F000
[Features]
Bus Mastering: Disabled
Running At 66 MHz: Capable
Fast Back-to-Back Transactions: Capable
[SATA Host Controller]
Interface Speed Supported: Gen3 6.0 Gbps
Number Of Ports: 1
External SATA Support: Not Capable
Aggressive Link Power Management: Capable
Staggered Spin-up: Not Capable
Mechanical Presence Switch: Not Capable
Command Queue Acceleration: Capable
64-bit Addressing: Capable
AHCI Status: Enabled
AHCI Version: 1.31
Ports Implemented: 0
[SATA Port#0]
Port Status: Phy in offline mode
External SATA Port: Not Capable
Hot Plug: Not Capable
[Driver Information]
Driver Manufacturer: Standard SATA AHCI Controller
Driver Description: Standard SATA AHCI Controller
Driver Provider: Microsoft
Driver Version: 10.0.18362.693
Driver Date: 21-Jun-2006
DeviceInstanceId PCI\VEN_8086&DEV_31E3&SUBSYS_126A1025&REV_03\3&11583659&0&90
Location Paths PCIROOT(0)#PCI(1200)