Nitro 5 turns off by itself automatically

@Shrimpanzee

Power Drain: Turn off the Laptop and unplug the charger. look at the back of your unit you can find a small pin hole. Put a paper clip in the pin hole and press and hold the paper clip for 40 seconds.

BIOS Default: Press the power button, as soon as you press the power button start pressing the F2 key repeatedly, so that you can see the BIOS page. In the BIOS page press F9 and press ENTER than press F10 and press ENTER. your unit will restart.

Click on 'Yes' if the comment answers your question!

Is it an an515-51?
Looks like this is the interlock interrupt button! Test by putting some layers of insulation tape so this button is pressed down!

All comments

@Shrimpanzee

Power Drain: Turn off the Laptop and unplug the charger. look at the back of your unit you can find a small pin hole. Put a paper clip in the pin hole and press and hold the paper clip for 40 seconds.

BIOS Default: Press the power button, as soon as you press the power button start pressing the F2 key repeatedly, so that you can see the BIOS page. In the BIOS page press F9 and press ENTER than press F10 and press ENTER. your unit will restart.

Click on 'Yes' if the comment answers your question!

Thank you so much

@Shrimpanzee

You welcome

I think I am the unlucky guy here since I tried to reset ny bios, tightened the screws and reset the battery but it still happens again and even worst than before

@Shrimp
It might be because of the OS problem . So you can try resetting the unit once and check. Even after resetting the unit if the issue persist than it might be a Hardware issue , so please try doing Reset but by doing Reset it will clean all your data on the Hard drive. So take a backup of the data and than do the Reset.

Navigate to Settings. ...
Select "Update & security"
Click Recovery in the left pane. ...
Click Get started under Reset this PC.
Click either "Keep my files" or "Remove everything,"
Click on remove everything
Than click on remove data and fully clean the drive

Try the step if the unit turns on, if not than i guess you need to contact Acer Support.
http://www.acer.com/worldwide/support/

Hit 'Like' if you find the answer helpful!

Click on 'Yes' if the comment answers your question!

What is the exact model of your notebook? Example v3-571!

Check if there is a power interrupt button similar to this one near the memory:

If you see a button that looks like this, it may not be pressed properly! To solve this, just put some layers of electrical tape covering the ram compartment!

So this is my nitro 5

Is it an an515-51?
Looks like this is the interlock interrupt button! Test by putting some layers of insulation tape so this button is pressed down!

Did the procedure work?

I am not sure... I did loosen the screw at the part on your screenshot and then tighten it back again which actually work for now. I did not try to open it because I was afraid that I might lose my warranty

You do not lose the warranty when you open the ram compartment! But be careful not to damage any part!

MarufAhmed

I was just playing game. The laptop was plugged in but suddenly it just turned off. I tried to turning it on . But nothing happend. And that it was not even charging.

@MarufAhmedIdeally, you create a new topic by clicking ask a question.

BhaskarV

egydiocoelho said:

Is it an an515-51?
Looks like this is the interlock interrupt button! Test by putting some layers of insulation tape so this button is pressed down!

My laptop doesn't have this button. Model is Nitro 5 AN515-52-593F.
Initially, issue started with turning off randomly. Now it stopped powering on completely with or with out power adaptor. I even tried by putting little longer object than the existing cushion in the RAM cover to press the sw2.
Now I'm worried. It is out of warranty.
Attached images. Any inputs on this issue?

Lynxi_

egydiocoelho said:

Is it an an515-51?
Looks like this is the interlock interrupt button! Test by putting some layers of insulation tape so this button is pressed down!

Do you put the tape on the cover or actually pressing down on the button, Ive put 7 kayers of tape on the cover and i still have the same problem (Power indicator turns on and in a few seconds it turn off, no fans running, no acer logo, no lit up keyboard when plugged in, nothing)