Gateway DX4870 integrated gpu and issues

Lacoursek2015
Lacoursek2015 Member Posts: 3 New User
edited March 1 in 2019 Archives
I have a Ipimb-ar Acer motherboard and my pc is a Gateway DX4870 I am having a huge issue.
I bought a Nvidia GT 630 that would not load past splash screen so I reset the cmos nd, when I did I then couldn't use my integrated  graphics plus now it beeps 1 long and 2 short.

(Notes)
*Reset Cmos again
*Re-seated card and now have removed it
*tried hdmi and vga ports
*taken ram out and replaced and switched around
*I have a 600 watt PSU 
*Mother board is fine cause I am using a radeon 4550 512mb and I am on the computer.

so does anyone have a clue why no graphics card wants to work and why my integrated is doing that?

btw tried to reinstall driver for integrated which is recognized and it says installed with problems. 

Answers

  • Sharanji
    Sharanji ACE Posts: 4,328 Pathfinder
    Lacoursek2015 

    Power down your computer, remove the GT card. 
    Power up you computer, go into your bios, disable secure boot, enable legacy devices, save/exit, 
    Power down, add Gt card and you should be good to go.

    Hit 'Like' if you find the answer helpful!   
    Click on 'Yes' if the comment answers your question!
  • Lacoursek2015
    Lacoursek2015 Member Posts: 3 New User
    There is no secure boot option on this bios 
  • Lacoursek2015
    Lacoursek2015 Member Posts: 3 New User
    anyone? have an answer
  • BPCD1999
    BPCD1999 Member Posts: 14

    Tinkerer

    The GT 630 could be bad. I recommend getting a new GPU for that computer