Is crucial p3 m.2 nvme ssd compatible with my acer swift 3 sf315-41?

kelsang
kelsang Member Posts: 1 Newbie
edited December 24 in Swift and Spin Series

is crucial p3 m.2 nvme ssd compatible with my acer swift 3 sf315-41( ryzen 5 2500u)?

[Edited the thread to add model number to the title and add issue detail]

Answers

  • GAMING6698
    GAMING6698 ACE Posts: 7,987 Pathfinder
    edited December 24

    If you have pre-installed HDD or Sata SSD then M.2 slot is likely empty where you can install your crucial P3 SSD.

    Yes, You can use a M.2 NVMe SSD PCIe3x2 or PCIe3x4. Crucial P3 is PCIe 3x4 interface.

    Check below link-

    windows 10/11 optimization guide for gaming 
    Windows 10/11 optimization guide for gaming — Acer Community

    My AN515-43 laptop UserBenchmark-
    https://www.userbenchmark.com/UserRun/51514566
  • billsey
    billsey ACE Posts: 34,645 Trailblazer

    You will want to clone the existing drive (either HDD or SSD) to the new one. If you are changing from a HDD to SSD then you can do that after the SSD is installed. If you are replacing an existing SSD then you will want to use an external NVMe case. Either way, with both drives connected use your favorite cloning app (I used the free version of Macrium Reflect that last time I did one) to clone the existing drive to the new one. When you are done with that you can use Disk Management to look at the partition on each drive. The only one that will have changed in size is the system partition, it will be adjusted to match the drive size. Once you are sure things went right, it's time to boot from the new drive. If you are doing the HDD to SSD move, go into the BIOS, turn on the boot menu option then boot using F12 to get the menu. Choose the SSD as your boot device and it should come up very quickly. If you are doing the SSD replacement, swap the two drives and just boot on the new one. Once you are up and running on the new drive and everything acts fine, go ahead an use Disk Management to wipe the partitions from the old drive so you can repurpose it as a data drive.

    In order to install a M.2 SSD you first remove the bottom cover (12 screws using a T6 driver) then pull up one section of the mylar that sits over the SSD shield, no need to remove the whole thing:

    Next take off the shield itself, enough to access the screw:

    And then just remove the screw to allow the SSD to be pulled up on the screw end to release it from the socket. Revers the process to put a new drive in that slot.

    Click on "Like" if you find my answer useful or click on "Yes" if it answers your question.