ES-11 wont boot up

13»

Answers

  • JackE
    JackE ACE Posts: 44,868 Trailblazer
    Check BIOS Information tab to see if HDD1 is still connected.


    Jack E/NJ

  • AdrianC
    AdrianC Member Posts: 36

    Tinkerer

    No its not listed
  • JackE
    JackE ACE Posts: 44,868 Trailblazer
    Then it's either not connected or has died. Did you perhaps disconnect it when you were in there earlier. I think we discussed doing that at some point so as  not to confuse matters.

    Jack E/NJ

  • AdrianC
    AdrianC Member Posts: 36

    Tinkerer

    No didnt go in. But will have look to see if disconnected. Thanks
  • AdrianC
    AdrianC Member Posts: 36

    Tinkerer

    Took back off and connection looked ok. Put back and its now appearing in bios..and now listed in Device Manager as Satafirm 11. But not appearing as a drive in Explorer. Makes me a bit twitchy about using the laptop and losing stuff again
  • AdrianC
    AdrianC Member Posts: 36

    Tinkerer

    Used Disk Manager and initialising it now. So hopefully sorted - but am reluctant to use for fear of it doing same again. Could the bad connection on SSD card caused probs with the emmc?
  • AdrianC
    AdrianC Member Posts: 36

    Tinkerer

    Spoke to soon got error message when initialising - request could not be performed because of an i/o device error

  • JackE
    JackE ACE Posts: 44,868 Trailblazer
    >>>Took back off and connection looked ok.>>>>

    Heh-heh. Can't just look at. Maybe you justled them a bit just opening the bottom cover and they worked intermittently for a while. You  actually gotta pull the ribbon connector off the mainboard. Remove 4 screws. And lift the drive out. Then re-seat the connector on the back of the drive a half dozen or so times to help tidy up the contacts just in case they're a bit diry or corroded. Also on the mainboard connector. Unplug the charger and disconnect the battery from the mainboard before attempting any of this stuff.



    Jack E/NJ

  • AdrianC
    AdrianC Member Posts: 36

    Tinkerer

    Did that. Tried then to initialise and came up with i/o error. I am thinking that time to cut losses and replace. 
  • JackE
    JackE ACE Posts: 44,868 Trailblazer
    Tried to initialize via Disk Manager?

    Jack E/NJ

  • AdrianC
    AdrianC Member Posts: 36

    Tinkerer

    yes after restarting