aspire v3-571g windows 8 oem recovery

hi

plz i need help regarding the recovery of windows 8.

the problem is that after i partitioned my 500gb hard drive into 4 drives i have not been able to make factory default backup through acer recovery management(hard drive configuration not default) nor use acer D2D in Bios(nothing happens when press alt+f10) to reset my computer.

Windows recovery partition Push Button Reset (13.78 gb) is intact. i cannot make it active probably due to gpt. yesterday i was playing around to find a cure and got my bootloader corrupted and spent the whole day recovering it. if any one wants to know how to correct this problem go to this link http://www.qliktips.com/2012/11/fix-windows-8-boot-issue.html.

So if anyone can help me to use that push button reset partition and link it to windows recovery it will be great.

ps .around two years back i used a intall.wim file of toshiba satellite l-655 and inserted it somehow into the recovery environment and got factory default settings and recovery working so there may be way for this too.

plz reply if anyone knows a workaround.

Accepted answers

firefoot007

i have found the sol after lot of digging into the Push Button Reset partition files .

use diskpart to rename the PBR partition as R and its type as ebd0a0a2-b9e5-4433-87c0-68b6b72699c7. now you can restore the system and can make a recovery drive. dont know about D2D.

All comments

firefoot007

i have also used pbrfix but ir ran only once and midway it gave error and now gives error at start. anyone know how to run it again? . i have restored to previous day also.

firefoot007

i have found the sol after lot of digging into the Push Button Reset partition files .

use diskpart to rename the PBR partition as R and its type as ebd0a0a2-b9e5-4433-87c0-68b6b72699c7. now you can restore the system and can make a recovery drive. dont know about D2D.

kamkik

Could you tell me exacly how you made it? I have these same problem... I have changed primary partition on 2 other partitions... and because of that i can't run RECOVERY in my acer v3-571g... and alt+f10 is not working... I have tried to back up these same settings like before by making only 1 patrition but it dosen't worr.. can you tell me hod did you do that? how to use diskpart and what to write...?

My screenshots:

zarzadzanie dyskami.jpg

Can you help me?

zarzadzanie dyskami.jpg

EASEUS.jpg

JackE

http://www.youtube.com/watch?v=YSdOc663AGw

Jack E/NJ

kamkik

It's not working with my problem... When I made like in the movie it is written to put RECOVERY DVD. It can't use RECOVERY partition. I think that after I partitioned my 500GB HDD the information on the drive which was responsible for using RECOVERY partition (during starting system and when it is started) has been deleted... And because of that I would like to know how the user firefoot007 made it to start recovery using RECOVERY partition.