ASAP predator Orion 640p motherboard ATX power connector layout

Bassfreak85

So basically what I'm going to do is take the connectors for my old power supply and splice them into the 18 + 10 pin PSU to 10 pin 12vo motherboard cable to a crosshair PSU and their adaptor cable.. Looking at the ten pin layout for the 12AO adaptor

I can splice the 5v pulldown for power on. 12v constant(+12v SB

And it shouldn't matter which one I use for 12v sense for regulation.

And the power ok I assume is 12v as well.

Only problem is I don't know which ones the constant, power ok and sense pins so I can splice the 10 pin motherboard side with the existing connectors.

Has anyone found the motherboard pin out?

I don't have a videocard right now but it'll still power up and I can probably check it.

I could probably find.the 12 sv by sticking a #18 into the pin connector and test it with my meter to eliminate that same with the 5v pulldown. Tgat being said I think the power ok and sense are both just 12v correct so I just have to find the 12 feedback from the board.

With that being said I would rather just have the pin out that way I don't burn everything up. Lol

Bassfreak85

https://community.acer.com/en/discussion/comment/1322965#Comment_1322965

Sweet. At this point I just need to find a 12 volt constant and the power okay I know I can pull a 12-volt sense from any one of the 12 volt outputs all is doing is regulating but I'm just not quite sure on the power okay I'm guessing I could probably pull another pin the 12 volt constant I will have to hook up power to it and turn the power supply and find out which pin is in fact 12 volts constant I'm just trying to find something a little more technical where I can streamline it I really appreciate it!