What are the manual-config settings for Acer S271HL

thejana
thejana Member Posts: 3 New User
in Monitors

My Acer montior, I used autoconfig, but the image is not centered properly when using autoconfig, then I manually configured the monitor but still, although I managed to make it better, the sides of the output image are left blank, I can't do anything ait it, I need to know what the default settings are, I also tried factory resetting the monitor, it still didn't work...

Resolution - 1366x768

Answers

  • Jack22
    Jack22 ACE Posts: 4,095 Pathfinder

    @thejana

    The picture might be helpful

    image.png

    Click on 'Yes' if the comment answers your question!
  • billsey
    billsey ACE Posts: 34,234 Trailblazer

    What port type are you using? Is there a reason for not displaying in the monitor's default 1920x1080 resolution? What refresh rate are you using? HDMI supports both 60Hz and 75Hz with your monitor.

    Click on "Like" if you find my answer useful or click on "Yes" if it answers your question.
  • thejana
    thejana Member Posts: 3 New User
    https://community.acer.com/en/discussion/comment/1236963#Comment_1236963

    No, it's set at my default monitor resolution and I'm using VGA as the port, as that's the only port there in the monitor. Also, the problem is not with the input, it's with the output that the monitor is giving, the image is not centered.properly when using autoconfig, and when using manual config, i still can't get the image to fit.properly in screen, I checked all the settings for hours but didnt get it to match.

  • thejana
    thejana Member Posts: 3 New User
    https://community.acer.com/en/discussion/comment/1236926#Comment_1236926

    I actually now how to edit the positioning of the image, but my problem is, after apllying the autoconfig, the manual settings won't get the image to fit properly in the screen no matter al the settings I tried, and as I said, autoconfig sets the screen offcenter a lot

Categories