Acer Nitro N50-610 Desktop Continuous Beeping after getting new ram

AdamskyPadamsky

Hi there, I don't know if this is the best category for this question but currently the PC/desktop I use is an prebuilt not custom Acer Nitro N50-610 but I am have trouble related to upgrading RAM. These are the the specs of my PC:

CPU: Intel i5-10400F
GPU: Nvidia GTX 1650
RAM before the upgrade: 12 GB Ram (the ram is from Micron and has a 4 GB stick and an 8 GB stick)
Motherboard: ACER DB.E1Z11.001 with Intel H470 Chipset

Yesterday, I bought a Corsair Vengence LPX 32 GB (2 sticks of 16 GB) RAM that has the speed of 3200 MHz and would be limited to 2666 MHz for me. I put the new RAM sticks correctly and in the exact slots where the 12 GB were but when I would turn on the pc with the new ram installed, it would do a non stop beeping noise and wouldnt start boot or connect to the display. When I put the old 12 GB of Ram in, it still didn't work so this is obviously an issue related to the new RAM. What can I do to fix this? Thanks.

AdamskyPadamsky

Forgot to mention that my motherboard has 4 slots of DDR4 available and is able to be upgradle to up to 64 GB RAM.

billsey

Corsaiir Vengence LPX is XMP 2.0 memory with a SPD Speed of 2133MHz. That might be too slow for your motherboard. It will not run at the overclocked rate of 3200 since XMP isn't supported. Here's the suppoted matrix for memory:

It's obviously incomplete since you had 12GB using one 8G and one 4G module, but in that configuration dual channel mode would be disabled due to the mismatched memory sizes. Return the Corsair and get two 16G 2933 or 2666 sticks plus a second 8G stick and use the two 16s and two 8s for 48G in total, as per the next to last row.