No boot device error

generalludd
generalludd Member Posts: 3 New User
While troubleshooting my Acer Aspire laptop, I messed up somehow. Now everytime i turn on my device, I see not bootable device found error.

On BIOS, info page, I can see both my SSD and HDD drives, but my computer is not booting up from those. 

How can I change the settings back to previous? 

Answers

  • JackE
    JackE ACE Posts: 44,871 Trailblazer
    (1) Tap F2 immediately after startup to re-enter the BIOS menu.
    (2)  Press F9 to load BIOS defaults.
    (3) Then press F10 to save BIOS default settings and exit.

    Jack E/NJ

  • generalludd
    generalludd Member Posts: 3 New User
    JackE said:
    (1) Tap F2 immediately after startup to re-enter the BIOS menu.
    (2)  Press F9 to load BIOS defaults.
    (3) Then press F10 to save BIOS default settings and exit.
    Did exactly like you instructed. Still facing the same issue. I made some changes using cmd and disk part. May be it is causing this issue. 
  • JackE
    JackE ACE Posts: 44,871 Trailblazer
    >>>I made some changes using cmd and disk part. May be it is causing this issue. >>>

    Do you recall what DISKPART> commands were used?

    Jack E/NJ

  • generalludd
    generalludd Member Posts: 3 New User
    JackE said:
    >>>I made some changes using cmd and disk part. May be it is causing this issue. >>>

    Do you recall what DISKPART> commands were used?

    As far as I remember, first I did disk part, then I did select dish 1 (my C drive), then I did select partition 3 (I selected the partition highest memory). Then I turned off the computer and restarted it. Since my restart I getting this no bootable device error.

    I did disk part because I was trying to install windows 10 and during the step where I need to select drive to install windows, no drive was showing. So i found the solution for it an Microsoft forum and followed it. 
  • JackE
    JackE ACE Posts: 44,871 Trailblazer
    What was the factory installed operating system, if any?

    Jack E/NJ