Nitro XZ272U display not full screen anymore

khraxxzul

Hi!

I own a Nitro XZ272U display and for the life of me I cannot figure out why it is not showing the screen image  full screen anymore (meaning, using the full panel).

I've looked everywhere in my windows settings; it is set to the native resolution of 2560x1440 and scaling is at 100%.
I also looked into the display settings I use a display port connection (DP 1.4) and the wide mode is set to 1:1 (changing this to Full or Aspect does not change it).

I have about a mm of panel left in the bottom and about 5mm on the top and both sides. 

I hope somebody can point me in the right direction...
Thanks in advance!

William_mk2

khraxxzul

Try to do power drain test on your monitor.. 

Unplug all the cables from the monitor
If the cable is inbuilt please don't try to remove it.  
Hold the power button for 1 minute
Plug all the cables back.
Turn on the monitor and check..

If it is not working fine ..

Using the control buttons on the monitor try to reset the settings to defaults and then check..   It should work fine..

To isolate the issue, try to use the same monitor to a different computer and check  or  Try to use an alternative monitor on this computer and check.