Desk monitor support information predator X34

ALE1967

Hi guys, I have an Acer predator ultra wide curved 3440x1440 monitor, I wanted to buy a desk stand, I just can't figure out which is the right one that fits with the attachment behind the monitor, can someone help me?

billsey

But is it an X34 SBMIIIPHZX, an X34 GSbmiipphuzx or one of the various X34 models not sold in the USA? For both of those it looks like when you remove the four screws that hold the stand to the back the holes match one of the VESA sizes, so any VESA mounting solution would work. Measure to see, they are likely on 100mm centers but might be 75mm. There may have been standoff studs that go there for a VESA mount in the box, but you could replace by stacking some nuts at each hole and using longer screws.

billsey

Good to know, please mark the appropriate message as the solution so your thread will rise higher in the searches.

billsey

We need to know which monitor you bought, there are a fair number of them that fit that description. What is the model number? Mine, which isn't likely to be the same as yours since mine is several years old, has mounting screw holes on the back to match a VESA mount.

ALE1967

The model number is X34

billsey

But is it an X34 SBMIIIPHZX, an X34 GSbmiipphuzx or one of the various X34 models not sold in the USA? For both of those it looks like when you remove the four screws that hold the stand to the back the holes match one of the VESA sizes, so any VESA mounting solution would work. Measure to see, they are likely on 100mm centers but might be 75mm. There may have been standoff studs that go there for a VESA mount in the box, but you could replace by stacking some nuts at each hole and using longer screws.

ALE1967

I bought it years ago on Amazon

Commodore_1995#

Can you submit a photo of this information stamp?

ALE1967

Wasn't that the right photo?

Commodore_1995#

Above the SNID, shows the model number?

ALE1967

This is the complete label

[Edited comment to delete personal information]

billsey

So, X34 bmiphz is the full model number. That's an earlier model than either the X34 S or X34 G. It looks like the mounting holes in the back where the stand screws on are VESA format, likely 75mmx75mm, but measure to make sure. I'm working off a photo of the back so it's not clear the placement size.

StevenGen

ALE1967 said:

Hi guys, I have an Acer predator ultra wide curved 3440x1440 monitor, I wanted to buy a desk stand, I just can't figure out which is the right one that fits with the attachment behind the monitor, can someone help me?

First you have to disassemble the OEM stand and measure the back plate 4x screws spacing’s to know which stand is applicable. There is no detail on measurements and/or size of the backplane to the x34 monitor. Below is a guide of how to disassemble this stand, so do that and measure your X34’s back plate and chose your appropriate desk stand that you want, as there are many. 

ALE1967

I took the height and width measurement

billsey

So, a standard VESA 100mmx 100mm mount will work. You may have to use some short standoffs to move the plate a bit farther away, but you can fabricate that with a couple of nuts and longer screws.

ALE1967

I purchased and installed it, thanks for your support

billsey

Good to know, please mark the appropriate message as the solution so your thread will rise higher in the searches.