Can't power on Aspire v3 571G

Dilruban
Dilruban Member Posts: 1 New User
edited November 2021 in Aspire Laptops
Aspire v3 571G.  After Power on, No bios & display the fan automatically off & restart again & again

Answers

  • JackE
    JackE ACE Posts: 44,868 Trailblazer
    First try pressing FN+F6 to toggle screen on. If still no screen follow these steps.
    (1) Press and hold power button till laptop shuts off
    (2) Unplug charger. No LEDs should be lit.
    (3) Remove the battery pack. Then press and hold power button for about a minute.
    (4) Plug charger back in but wait till battery charge LED turns from steady orange to steady blue
    (5) Only after battery charge LED turns steady blue, turn laptop back on and immediately press the F2 key to try enter the BIOS menu
    (6) Press F9 in the BIOS menu to load defaults. Press F10 to save defaults and exit the BIOS menu
    (7) Laptop should start Windows login normally

    If still no screen at step 5, does a TV screen work via HDMI cable out to a TV set and pressing FN+F5?



    Jack E/NJ

  • Easwar
    Easwar Member Posts: 6,727 Guru
    Hi @Dilruban,

    Try to do power drain,

    1. Shutdown the unit.
    2. Unplug the cables connected to the unit.
    3. At bottom of the unit there will be a small tiny pin hole with a battery symbol close to it. Take a pin or a paper clip insert into it you feels like pressing a button hold it for 20-30 seconds. 
  • JackE
    JackE ACE Posts: 44,868 Trailblazer
    First try pressing FN+F6 to toggle screen on. If still no screen follow these steps.
    (1) Press and hold power button till laptop shuts off
    (2) Unplug charger. No LEDs should be lit.
    (3) Remove the battery pack. Then press and hold power button for about a minute.
    (4) Plug charger back in but wait till battery charge LED turns from steady orange to steady blue
    (5) Only after battery charge LED turns steady blue, turn laptop back on and immediately press the F2 key to try enter the BIOS menu
    (6) Press F9 in the BIOS menu to load defaults. Press F10 to save defaults and exit the BIOS menu
    (7) Laptop should start Windows login normally

    If still no screen at step 5, does a TV screen work via HDMI cable out to a TV set and pressing FN+F5?

    Jack E/NJ