SSD Raid 0 via intel RST - Nitro 5

Revention01
Revention01 Member Posts: 2 New User
edited September 2021 in Nitro Gaming
I recently added another 512gb ssd nvme. so it is now 1 256gb WD and 512gb kingston. it was not detected in windows however detected in bios. what i did is to set a raid 0 using intel optane and storage management software. my stock WD that came with the Nitro 5 became 512gb however, im at lost. i am missing 250gb worth of storage. how can i remove the raid 0 configuration and make the drives separated.

//Edited the content to add model name.

Answers

  • Leostat
    Leostat ACE Posts: 3,043 Pathfinder
    Did you initialise the raid 0 array using the two drives? If so, I don't think there is a way to do it without re installing the drive as the data will be physically stropped across the two drives, hence the missing 250gb 

    You could try pulling the smaller drive to see it is part of the array, if it boots you are in luck, if you get a warning you are foobard, only way is backup what's on the drive and reinstall windows . 
  • Revention01
    Revention01 Member Posts: 2 New User
    Leostat said:
    Did you initialise the raid 0 array using the two drives? If so, I don't think there is a way to do it without re installing the drive as the data will be physically stropped across the two drives, hence the missing 250gb 

    You could try pulling the smaller drive to see it is part of the array, if it boots you are in luck, if you get a warning you are foobard, only way is backup what's on the drive and reinstall windows . 
    hi thank you for the response, the smaller drive is part of the array, if i remove it the larger ssd is not detected vice versa, i tried reinstalling on the larger ssd, yes it was a success however i am still missing the smaller ssd.
  • What is the exact model? Example an515-51-75kz. Is windows 10 installed on any drive the raid was mounted on? I ask this question, because if windows is installed, the only option is to backup and before reinstalling windows, delete the volume.
    Within the windows installation, press shift+f10 and type these commands:
    diskpart
    list vol
    sel vol x
    delete volume

    Afterwards, the two units must be seen separately.
    Oi! Eu não sou sou a cortana! Mas estou aqui para ajudar! Hi! I'm not the cortana! But I'm here to help!
    Se você gostou da minha resposta, marque como solução clicando em sim! If you liked my answer, mark it as a solution by clicking on yes!
    Aceite somente a resposta que ajudou a solucionar o seu problema! Please accept only the response that helped to solve your problem!
    Detection tool click here to find the serial number or partnumber of your model!                                                          
                                                      
                                                     egydiocoelho Trailblazer
     
    ProductKey clique aqui para descobrir o serial do windows! click here to discover the windows serial!
    Para usuários da comunidade inglesa, espanhola, francesa e alemã, usarei o google tradutor! :)
    For users of the English, Spanish, French and German community, I will be using google translator! :) 
  • Leostat
    Leostat ACE Posts: 3,043 Pathfinder
    Once you re install, does the drive show in disk management? It may need re initializing and a partition adding manually , if it's RAW after being part of an array it may not be showing, 

    Also it may need swapping out of raid mode as it may just be forcing it to be ignored :)