Acer one 10 not booting from windows 10 bootable pendrive

S1003

By ! Thank you

S1003

Hi JackE

Today I made a bootable pendrive of earlier version of windows 10 (I.e 1604) with rufus ,When I booted I got BSOD error saying ACPI BIOS ERROR 

S1003

I think this laptop does not support 20h2 version

JackE

It should. Check the S1003 ACER driver download page to make sure you have latest BIOS firmware installled. Go to the advanced section on the installation menu. Try to get to the X : \ command prompt. From there you can run diskpart to can run the follow diskpart commands.

List Disk

Select Disk 0 (the emmc)

Clean

Then exit diskpart and the X : \ command prompt and try to install it again. Remember you must insert an NTFS formatted SDCard to hold temporary Win10 files to complete the installation.

Jack E/NJ

S1003

Can you search and give me advice to install which update ,I searched on website there are 7-8 updates in BIOS AND FIRMWARE 

JackE

Sorry. You cannot easily or directly install BIOS firmware updates until you have successfuly installed Windows. Jack E/NJ

S1003

So what should I do as it boot it shows me acer logo and loading starts but it immediately stops and takes me to BSOD ERROR saying ACPI BIOS ERROR And restarts and continues the same process 
I've tried :
pressing f12

S1003

I ve also tried to press alt+f10,fn+f9

S1003

There are minimal setting in UEFI FIRMWARE setting there's no security, advanced ,power management etc. Tabs. I've also tried to enable additional options in insydeh20 rev 5.0 as shown in this video 👇
https://youtu.be/9y7kCZS7Jjo
But nothing happened 

S1003

And I cannot understand which update for bios and FIRMWARE on acer drivers site 👇
https://www.acer.com/ac/en/US/content/support-product/6822?b=1&pn=NT.LCQEM.001

egydiocoelho

what happens when you disable SECUREBOOT?

S1003

It allows windows bootable pendrive to boot (but only to give bsod error) and doesn't allow prime os to boot 

JackE

As mentioned earlier, if you can boot from the pendrive then go to the advanced section on the installation menu. Try to get to the X : \ command prompt. From there you can run diskpart to can run the follow diskpart commands.

List Disk

Select Disk 0 (the emmc)

Clean

Then exit diskpart and the X : \ command prompt and try to install it again. Remember you must insert an NTFS formatted SDCard to hold temporary Win10 files to complete the installation.

Jack E/NJ

S1003

I can't boot(as it boots on loading two dots come and loading stops and it gives me BSOD error just like windows 8.1 but the code is different the code is ACPI BIOS ERROR )

S1003

I've also tried to boot with third party software like ease us winpe disk

S1003

But I've not downloaded it from official website as it requires pro version which is very costly

S1003

Every winpe disk Creator requires subscription 

S1003

That's why I was not able to see winpe disk in boot menu

S1003

I've tried tapping fn+f9 and alt+f10

S1003

But it didn't work