HELP! HIGH TEMPERATURE WITH "SYSTEM" ON PREDATOR SENCE- PREDATOR Helios 300 2020

JavierGomez

Hi, i have this trouble. I have a Predator Helios 300 2020 PH315-53 RTX 2060 and I dont know what I have to do to calm the highest temperature that my lap produce.
That temperatures were when I was playing CyberPunk 2077. CPU and GPU temperatures are ok but the SYSTEM is on fire. The TURBO mode in predator sence was on in that moment, the fans were in maximum. Somebody knows what I have to do to fix that problem.
Today I replaced the original thermal paste, I've used MX4. The image of predator sense is after change the thermal pasted.
Here is some pictures inside the lap before change the thermal paste.
THANKS.
 

GAMING6698

@JavierGomez
Which method you used to apply themal paste and after applying did you open heat sink again?

JavierGomez

@GAMING6698
I applyed as a "rice form" in both, cpu and gpu (in picture only appears thermal paste in CPU but I applyed in both after). But the problem isnt in CPU and GPU, the temperatures are good. The problem is with the System (PCH). This temperature of PCH is when Im playing RED DEAD REDEMPTION 2 in ultra settings. 

GAMING6698

@JavierGomez
1)Follow these steps one by one-
First clean Fans and air vents-

https://youtu.be/uB39PPoHBpo
(Follow this above video to clean fans and air vents)

20Thermal paste method-Use medium size X method according to size of your GPU/CPU to get best cooling.
And after applying x method just assamble heat sink again.
(Note- After applying paste and heat don't open heat sink again otherwise air bubbles go inside and affect your cooling)
(X method shown in below video)

https://youtu.be/JYwHB2P6GmM

Batareika007

Hi, it's been a while, did you find solution ?

I have same issue after repasting.

vanillapancake1

Bump, I have the same issue too

xapim

@JavierGomez use kryonaut and the spread method only a thin layer covering both diodes its enough too much paste its bad same as too less any high temps after repasting its a bad repaste re do it again until u get it right  good luck

TamHoangNgoc

Looks like my answer was too late.
Hope it will still be useful to a few others.
The reason here lies in the Power Plan. If you set Power Plan to High Performance, the System temperature will always be 80 degrees Celsius or higher.
If you choose Power Plan as Acer (which is already provided), the System temperature will be about 50~70 degrees Celsius.

Also, don't forget to clean your laptop periodically and replace the thermal paste.