CB281HK PIP/PBP with DisplayPort and HDMI
lundgren
Member Posts: 2 New User
I have a CB281HK connected via DisplayPort and HDMI to two separate machines.
I can select the DP or the HDMI as my input and they work fine.
When I try to use PIP or PBP it always uses the DVI with either DP OR HDMI, but I cannot seem to get it to use the DP and HDMI instead of the DVI. Is there a setting some place for this I am missiing?
Thank!!!
I can select the DP or the HDMI as my input and they work fine.
When I try to use PIP or PBP it always uses the DVI with either DP OR HDMI, but I cannot seem to get it to use the DP and HDMI instead of the DVI. Is there a setting some place for this I am missiing?
Thank!!!
0
Best Answer
-
I finally found it.
Go into
MENU->Setting->PNP/PBP->Sub Source:
In there you can pick DP/HDMI/DVI
Mine was set to DVI. Just pick the secondary to be either DP or HDMI.
Using DP and HDMI now.1
Answers
-
As far as I checked about similar concerns with other manufacturers, the answers all lead towards one conclusion, that it depends on which one among DVI and HDMI is set as primary video by the manufacturer.0
-
I finally found it.
Go into
MENU->Setting->PNP/PBP->Sub Source:
In there you can pick DP/HDMI/DVI
Mine was set to DVI. Just pick the secondary to be either DP or HDMI.
Using DP and HDMI now.1