My system is Acer Aspire TC-220
I have just installed a: PSU: Corsair VS450 450 Watt Fully Wired 80+ White PSU/Power Supply
I have just installed a: GPU: Palit NVIDIA GeForce GTX 1050 2GB STORMX Graphics Card
On my p.c and have had no problems at all.
The problem has started when i removed my old HDD and replaced it with a : SSD: WD Green 240GB 2.5" SATA 3D NAND SSD/Solid State Drive
Things i done:
- Acer Care Center Recovery Management and done "Create Factory Default Backup" on a USB
- Shut down p.c and removed old HDD and replaced it with the SSD
- Plugged in Create Factory Default Backup USB into p.c
- Booted up p.c and then pressed F12 which showed my USB
Went and done a fresh install but when it gets to about 72% it stops and the screen changes and says "There was a problem resetting your p.c, no changes were made "
Tried about 4-5 times and still the same, come 72% and it fails again.
I have had to put my old HDD back in until i can get a workaround.
Any ideas what could be causing this?
All the best